Multiquip MC3PE, MC3SE, MC3S (B&S), MC3P (B&S) manual MIX N GO Mixer Initial START-UP Electric Motor

Page 22

MIX N' GO MIXER — INITIAL START-UP (ELECTRIC MOTOR)

Initial Start-up Instructions (Electric Motor)

Starting

CAUTION:

DO NOT attempt to operate the mixer until the Safety, General Information and Inspection sections have been read and understood.

1.Before starting, make sure mixer is positioned on a secure flat surface to prevent tipping.

2.Use an extension cord (see Table 5) of adequate current carrying capacity, insert the electric motor's power plug into one end of the extension cord.

3.NEVER! use a worn or frayed extension cord.

4.NEVER! operate mixer withV-belt cover removed.

5.Plug the other end of the extension cord into a 120 VAC G.F.C.I.protected receptacle. Rememberthepowerrequire- ments for this electric motor is 120 VAC, 60 Hz. The use of any other input voltage will severely damage the motor.

WARNING:

ALWAYS read the label on the electric motor before applying power.The label will indicate the proper power requirements for the motor. Remember the use of any other input voltage will severely damage the motor.

WARNING:

To prevent tripping (Figure 18) of both the mixer and personnel, position the extension cord so that it lays flat and is not curled underneath the mixer.

Table 5. Extension Cord Size

No. 12 Wire

No. 10 Wire

No. 8 Wire

No. 6 Wire

 

 

 

 

50 (feet)

75 (feet)

100 (feet)

200 (feet)

(15.24 meters)

(22.86 meters

(30.48 meters

(60.96 meters

 

 

 

 

DANGER

NEVER! touch the power cord (Figure 17) with wet hands or while standing in water when it is connected to a power source.The possibly exists of electrical shock (electrocution) even death. NEVER! spray

water directly on the electric motor.

WET

HANDS

POWER

CORD

(POWER ON)

Figure 17. Extension Cord (Wet Hands)

Figure 18. Mixer (Tripping)

6.The drum should be rotating allowing the mixing process to begin. Use a shovel (Figure 19) to place the cement mix inside the drum, add water as required. Be careful to only placethetipoftheshovelinsidethedrum.Placingtheshovel all the way inside the drum will cause the shovel to strike the blades. This condition will make the shovel rotate, and could cause injury to personnel.

Figure 19. Mixing Drum (Placing Cement Mix)

6.SeeTable 3 for mixing hints.NEVER!place hands inside the drum while the drum is rotating.

PAGE 22 —MIX N' GO MIXER — OPERATION & PARTS MANUAL — REV. #5 (1/07/05)

Image 22
Contents MIX N GO Mini Concrete Mixer Steel Drum Models Page Heres HOW to GET Help Table of Contents Parts Ordering Procedures MIX N GO Mixer Safety Message Alert Symbols Foryour Safety and the Safety of OthersMIX N GO Mixer Safety Message Alert Symbols Sight and Hearing hazard Equipment Damage MessagesGeneral Safety Rules for Safe OperationRules for Safe Operation Emergencies Operation and Safety Decals Machine Safety DecalsOperation and Safety Decals Advertencia AvertissementDry Net Weight MIX N GO Mixer SpecificationsDimensions L x W x H ModelMIX N GO Mixer Dimensions Mixer MIX N GO Mixer Dimensions Electric Motor Electric MotorMIX N GO Mixer General Information MIX N GO Mixer Mixer Components MIX N GO Mixer Basic Engine Engine Controls and ComponentsMIX N GO Mixer Assembly Instructions AssemblyMIX N GO Mixer Assembly Instructions Engine Oil Check MIX N GO Mixer PRE-INSPECTION Gasoline EngineBefore Starting Fuel CheckMIX N GO Mixer Initial START-UP Electric Motor Initial Start-up Instructions Electric Motor StartingMIX N GO Mixer Initial START-UP Gasoline Engine Starting the Engine Briggs & StrattonMIX N GO Mixer Initial START-UP Gasoline Engine Stopping The EngineMIX N GO Mixer Maintenance Maintenance Gearbox Oil CheckMIX N GO Mixer Maintenance Gasoline Engine Engine Maintenance ScheduleMIX N GO Mixer Maintenance Gasoline Engine MaintenanceMIX N GO Mixer Preparation for Long -TERM Storage MIX N GO Mixer Operation & Parts Manual REV. #5 11/07/05 MIX N GO Mixer Troubleshooting Engine Engine TroubleshootingMIX N GO Mixer Troubleshooting ENGINE/MIXER Engine TroubleshootingMIX N GO Mixer Explanation of Code in Remarks Column Items Found In the Items Number ColumnMIX N GO Mixer Suggested Spare Parts To 3 UnitsMIX N GO Mixer Name Plate and Decals Name Plate and DecalsDecalwarning MQ MIX N GO Mixer Mixer ASSY. Steel Drum Part Name QTY Remarks MIX N GO Mixer Mixer ASSY. Plastic Drum Part Name Terms and Conditions of Sale Parts FreightpolicyMIX N GO Mixer Operation & Parts Manual REV. #5 11/07/05 Multiquip INC
Related manuals
Manual 72 pages 57 Kb