Omega TX82B manual Installation/Removal, Exploded View includes rear panel

3.3INSTALLATION/REMOVAL

The TX82B is housed in a 1/8 DIN case. The electronic circuitry can be installed or removed from the front and is attached to the case with two M4 screws through the rear panel.

Panel Mounting

1.Remove the two thumbnuts on the rear of the case.

2.Slide the sleeve off the case (see Figure 3-1 Exploded View).

3.Verify the panel cutout dimensions in Figure 3-2 Case Dimensions. Insert the case in the panel cutout from the front and slide the sleeve on from the rear. Install the two thumbnuts to secure the sleeve to the case.

Main Board Access:

1.Case must be removed from sleeve.

2.Remove lens from case.

3.Slide main board from front of case.

CASE

ID. LABEL

REAR PANEL

MAIN BOARD

DISPLAY

BOARD

PANEL

THREADED STUD

THUMBNUT

SLEEVE

CONFIGURATION LABEL

(BACK SIDE OF DISPLAY BOARD)

FRONT LENS

J3	B	REAR CONNECTOR (P3)
		FOR SIGNAL INPUT
DO NOT RUN OR
ELECTROSTATIC RISK
CLEAN WITH SOLVENT		1 2 3

Figure 3-1 Exploded View (includes rear panel)

5