Getting started, Mass unit switchover, Weighing

ENGLISH

Fitness Scale 7850

■Getting started

1.Install the fitness scale level on a firm, flat surface

2.Connect the plug-in power supply unit without standing on the scale

3.Set the clock and date

Please do not stand on the scale. Keep the + or – Key pressed until the display shows the year. Press the + or – key to select the required year and confirm. Select the month by pressing the + or – key and confirm. Select the day by pres- sing the + or – key and confirm. The indicator then shows digits for setting the clock. Adjust the hour by using the + or – key and confirm. Do the same with the minutes and finally confirm.

4.Insert the thermal paper roll (58mm wide)

in the paper compart- ment (see figure) and

pull out the paper strip by several centimetres. Close the lid and tap

the key “7850” briefly

to test whether the paper feeds through cor- rectly. The printer has an easy-load function. There is no need to feed the paper through manually.

■Mass unit switchover

Slide the switch on the rear at any time to switch over the mass unit from “kg and cm” to “lb and ft/inch“ or “st/lb and ft/inch”.

The default setting of the scale is “kg and cm". The last unit setting is retained even when the appliance is switched off.

0.0 kg

0.0 lb

0: 0.0 lb

■ Battery exchange:

Please change the lithium battery when time

and date settings are not correct anymore (without power supply of the scale)

■Weighing

Stand on the scale as still and straight as possible while the Fitness Scale measures your weight. After a short period of time, the weight reading appears and the “INPUT" message flashes. If you only want to measure your weight, you can step off the scale now. The weight reading is printed out. Otherwise continue as described under Body Analysis.

5. The scale is ready to operate	72.2 kg