Grizzly T10007 owner manual Service, Troubleshooting

SECTION 6: SERVICE

Troubleshooting

Symptom	Possible Cause		Solution
No display when	1.	Battery is dead or damaged.	1.	Check and charge or
the scale is turned				replace battery.
ON.	2.	Battery contact is loose.	2.	Tighten the battery contact.
Display flashes.	1.	Low battery.	1.	Recharge battery.
Scale will not turn	1.	ON/OFF button is damaged.	1.	Check and clean the button
ON or OFF.				and button contact.
	2.	Scale is still in function mode.	2.	Exit out of the function to
				the main screen, then turn
				OFF the scale.
Display will not	1.	The load is unstable.	1.	Stabilize the load.
show a stable	2.	Load cell cable is damaged.	2.	Check and replace load
weight.				cell.
	3.	The scale has been in a damp	3.	Put the scale in a dry envi-
		environment for a prolonged		ronment.
		amount of time.
Recharge indicator	1.	Damaged adaptor.	1.	Check or replace the adap-
light will not turn				tor.
ON.	2.	The adaptor is not fully	2.	Insert the plug again.
		plugged into the scale or out-
		let.
Scale unable to	1.	Damaged TARE button.	1.	Check and clean the button
tare.				and button contact.
Large weight error.	1.	Scale is not suspended prop-	1.	Check the scale, har-
		erly.		nesses, etc. Review Setup
				section on Page 4.
Battery unable to	1.	Battery is damaged.	1.	Replace the battery.
charge.	2.	Outlet is damaged.	2.	Replace the outlet.
Remote will not	1.	Remote control is too far away	1.	Move the remote closer to
work.		from the scale.		the scale.
	2.	Dirty receiver window.	2.	Check and clean window.
	3.	Remote control batteries are	3.	Replace controller batter-
		low.		ies.
The display will not	1.	The scale has not had enough	1.	Allow the scale to warm up
show "0" with an		time to warm up.		for 3-5 minutes after turning
empty load.				it on.
	2.	The scale has been placed on	2.	Suspend the scale.
		the ground and not suspended
		for a prolonged time.

Model T10007 300 Kg Digital Crane Scale -11-