PREPARATION
Installing Batteries / Connecting the AC Adapter
Installing Batteries
CAUTION When replacing batteries, be careful 
not to apply too much force to the 
weighing platform. An excessive
force could damage the scale. 
Unlock and remove the battery cover. (See illustration at the right) Insert six new batteries (R20P / LR20 / D size) into the battery compartment, taking extreme care to that the plus and minus polarities are observed.
Be sure to install and lock the battery
cover after installing the batteries.
New six batteries. (R20P/ LR20/ D size)
AC Adapter (Optional)
CAUTION When using an AC adapter, the
scale doesn’t comply with IP65. 
The AC input requirement
could be 100, 120, 220, 230 or 240 volts (50/60Hz) depending on the area where used, so please verify that the adapter is the correct type.
Plug the AC adapter to the AC adapter socket inside the battery compartment.
Setting up the Scale
CAUTION Avoid installing the scale in direct sunlight, that may cause discoloration or malfunctions. Place your
Place the scale on a firm surface and adjust the feet to level the scale, while using the sprit level, for accurate weighing.
- 3 -