A&D SK-5001WP, SK-20KWP, SK-10KWP, SK-2000WP, SK-1000WP Before Weighing, Weighing Procedures

Page 5

WEIGHING

Before Weighing

Automatic Power-Off Function.

If the scale is left ON and the stable indicator is displayed, the automatic power-off function turns the power off after approximately five minutes (factory setting). To disable or enable the function, press the [ON/OFF] key while pressing the [RE-ZERO] key. The scale stores this setting. To verify this, press both the [RE-ZERO] and [UNITS] keys while in the weighing mode. (See "CALIBRATION" about the [UNITS] key.)

poff0

Error Message

e

-----

lb

Function disabled

poff1

Overload

The scale zero is out of range Low battery

Function enabled

Calibration May be Required Before Weighing

Read “CALIBRATION” first and if necessary, calibrate your scale for accurate weighing.

Weighing Procedures

1.Turn on the scale.

Press the [ON/OFF] key to turn on the scale. Then the scale displays all segments for a few seconds and then 0 will be displayed.

2.Start weighing

If you do not use a container for weighing,

Press the [RE-ZERO] key to display 0 . Verify the reading is 0 .

Place objects on the weighing platform to weigh.

is displayed.

When the reading becomes stable, the stable indicator

If you use a container for weighing, Place an empty container on the platform.

Wait for the stable indicator to be displayed and press the [RE-ZERO] key. Place the objects to be weighed in the container. When the reading becomes stable, the stable indicator is displayed.

Select the weighing unit, --- Only for the “(k)g-lb” model---

If you use the (k)g-lb model, press the [UNITS] key to select weighing with either (k)g or lb as the unit.

Normally scales power up in lb when shipped from the factory. To power up in (k)g, turn the scale off. Press and hold the [UNITS] key, then press the [ON/OFF] key. The scale will start with (k)g. To return to the original setting, repeat this instruction.

- 4 -

Image 5
Contents SK-10KWP SK-20KWP SK-30KWP Safety Precautions Display Parts DescriptionPreparation Installing Batteries / Connecting the AC AdapterSetting up the Scale Before Weighing Weighing ProceduresWeighing Calibration When to CalibrateCalibration Using a Calibration Weight Select a digit to be changed Calibration by Gravity CompensationSet the new value Save the value in memoryValue of Gravity at Various Locations SpecificationsWorld Map 95131 U.S.A