Pressure Relief Procedure
6 309477F
Pressure Relief Procedure
1. Turn OFF power switch.
2. Unplug sprayer.
3. Turn Prime/Spray valve to PRIME. Trigger gun to
relieve pressure in hose.
4. Engage trigger safety.
If you suspect the spray tip or hose is completely
clogged or that pressure has not been fully relieved after
following the above steps, VERY SLOWLY loosen the tip
guard retaining nut or hose end coupling to relieve
pressure gradually. Then loosen it completely. Clear tip
or hose obstruction.
To help prevent injuries, follow this procedure
when you stop spraying and before you service or
clean the sprayer, remove parts or repair leaks.
ti2011
dx model XR9 model
ti2018a
ti2021a1
Leave Prime/Spray valve in PRIME position until
you are ready to spray again.
to2012a
ti2048a