Philips FW798W manual Setup, Positioning the speakers, General hints for positioning

Page 13

Positioning

Position the unit in a way that you are able to ”see” the active surround speaker from the position of the unit.

To avoid sound distortions caused by magnetic fields do not place the transmitter on your TV set.

FRONT

L

14 V

TV

SURR

SURR PRE OUT

FRONT

R

SETTING UP FB219W

Setting the input sensitivity A.B.C

Depending on which sound source you use, the signals delivered have different strengths.

If the red light on the front of the transmitter unit starts to blink, the incoming signal is too strong. This will cause distortions. Set the A·B·C switch to adjust the input sensitivity to a lower level.

English

Positioning the speakers

Important!

To avoid overheating do not cover any vents and leave a minimum distance of 5 centimeters (2 inches) for ventilation.

General hints for positioning

 

CENTER

SURROUND

SURROUND

REAR

REAR

MAINS

MAINS

If the red light on the front of the transmitter unit goes off during play, the incoming signal is not strong enough. Set the A·B·C switch to adjust the input sensitivity to a higher level.

Setting the transmitting channel In case of signal interference from the

Avoid positioning the speakers in a corner or on the floor, as this will boost the bass tones too much. Placing the speakers behind curtains, furniture etc. will reduce the treble response, thus reducing the stereo effect considerably. The listener should always be able to ”see” the speakers.

Each room has different acoustic characteristics and the positioning possibilities are often limited. You can find the best position for your speakers by following the picture above. The speakers should always be arranged as symmetrically as possible in the room.

Positioning the center speaker

The center speaker should be placed in the center between both front speakers, e. g. underneath or on top of the TV. The best height for the center speaker is at the height of the listener’s ears (while seated).

Positioning the surround speakers The surround speakers should face each other and be in line with, or at most 1.5m (4ft 6ins) behind the listener.

Setup

Adjusting the relative sound level After installing your speakers, you will have to find a good sound balance between the surround, center and front speakers.

In the instruction booklet of your appliance you will find a section describing how to adjust the sound of the different speakers. Follow those instructions to get the most out of your new speakers.

transmitter it is possible to change to another transmitting channel.

1Switch off both active surround speakers.

2Set the CHANNEL slide at the back of the transmitter to another number.

3Set the CHANNEL slide at the back of both active surround speakers to the same number as on the transmitter.

4Switch on both active surround speakers.

Note:

–Always be sure that the transmitter and the active surround speakers are switched to the same transmitting channel, otherwise no sound or only a distorted sound will be heard on the surround speakers.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents FW798W Warranty Verification Dear Philips product owner Congratulations on your purchase, and welcome to the familySet complies with the FCC-Rules, Part 15 and with 21 CFR AvisClass Laser Product Safety Instructions Read before operating equipment Safety Instructions WHO is COVERED? Audio SystemContents Preparation FM Wire Antenna ConnectionAM Loop Antenna Connection Speakers ConnectionWireless Surround Out Connection Remote ControlConnecting other Equipment to your system AC Power SupplyTransmitter Setting UP FB219WActive surround speakers ConnectionsPositioning SetupPositioning the speakers General hints for positioningDolby Pro Logic Dolby PRO LogicTest Tone BalanceDolby 3 Stereo Dolby SurroundDolby Center Phantom Normal StereoStandbyon ControlsControls on the system and remote control Sleep Timer Demonstration modeControls Operating the System ShuffleSwitching the system to standby mode Switching the system onEasy Set Selecting the SourceTo switch off DBB For neutral setting, select Classic and switch off DBBMute on remote control only Playing a CD Loading the CD ChangerDisc Change Discs for playbackProgramming Tracks Selecting a desired trackReviewing the program Playing the programPlayback TunerDisplay Tuning to Preset Radio Stations Storing Preset StationsAutomatic programming Manual programmingTape When playback is stoppedTape Playback Loading a tapeThere are two AUX modes Normal AUX mode When you release ˆor ‡, the tape continues playingSelecting External Equipment During playbackRecording Only Œ or ¶ mode is available during recordingOnly on tape deck Press Tape Tape 12 to select tape deckOne Touch Recording CD Synchro Start RecordingDigital Recording via Digital Out Dubbing will start immediatelyTimer Setting TimerClock Setting ClockMaintenance Timer Sleep Timer MaintenanceSpecifications SpecificationsCD Player Operation TroubleshootingRadio Reception Tape Deck OperationFB219W

FW798W specifications

The Philips FW798W is a notable entry in the world of compact audio systems, delivering a potent combination of robust performance, modern design, and versatile features. Designed with the audiophile in mind, this mini Hi-Fi stereo system is packed with advanced technologies that ensure superior sound quality and an enriching listening experience.

One of the standout features of the FW798W is its powerful output, capable of delivering dynamic sound that fills any room. The system often incorporates high-quality speakers that are engineered to produce clear highs, rich mids, and deep bass, creating an immersive audio environment for music, movies, and games alike. The overall design is compact yet sleek, allowing it to blend seamlessly into various home aesthetics while saving space.

The Philips FW798W is equipped with multiple sources for audio playback, including CD, FM/AM radio, and USB input, broadening its versatility. Users can enjoy their favorite CDs, listen to live radio broadcasts, or play music directly from their digital devices via USB, ensuring that one’s music library is always accessible. The system also features Bluetooth connectivity, allowing users to effortlessly stream music from smartphones, tablets, or other Bluetooth-enabled devices, making it even more user-friendly.

Moreover, the FW798W employs advanced audio technologies such as Digital Sound Control and Dynamic Bass Boost, which allow users to tailor their listening experience according to their preferences. Whether you prefer a more subdued sound profile or something with a punchier bass, these features ensure that you can manipulate the settings for optimal enjoyment.

The unit's user interface is designed with convenience in mind, often accompanied by a remote control that simplifies navigation through tracks and settings. A clear LED display provides essential information on tracks and radio stations, contributing to a more intuitive user experience.

In summary, the Philips FW798W stands out in the compact audio system market due to its impressive sound quality, extensive playback options, and user-friendly operation. Whether for casual listening or immersive experiences, this system caters to a variety of audiophile needs, making it a worthy addition to any home audio setup.
Top Page Image Contents