Philips FW798W manual Troubleshooting, CD Player Operation, Radio Reception, Tape Deck Operation

Page 32

English

TROUBLESHOOTING

WARNING! Under no circumstances you should try to repair the set yourself as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock.

If a fault occurs, check the points listed below before taking the system for repair.

Should any problems persist after you have made these checks, consult your nearest dealer or service center.

CD Player Operation

NO DISC” is displayed.

The disc is inserted upside down.

ª Place CD with printed side up.

Moisture condensation at the lens.

ª Wait until lens has adjusted to normal room temperature.

There is no disc in the CD tray.

ªInsert a CD.

The CD is dirty, badly scratched or warped.

ªClean or replace the CD.

• The CD lens is dirty or dusty

ªSee section under Maintenance.

DISC NOT FINALIZED” is displayed.

The CD-RW or CD-R disc is not properly recorded for the use on a standard CD player.

ªRead the instruction booklet of your CD- ReWriteable or CD-Recorder on how to finalize a recording.

The CD is badly scratched or dirty.

ª Replace or clean CD.

Radio Reception

Poor radio reception.

The signal is too weak.

ª Adjust the antenna.

ª Connect an external antenna for better reception.

The TV or VCR is too close to the stereo

system.

ªSeparate the stereo system from the TV or VCR.

Tape Deck Operation

Recording or playback cannot occur or there is a decrease in audio level.

Dirty tape heads, capstans or pressure rollers.

ªSee section on tape deck maintenance.

• Magnetic build-up in the record/ playback head.

ªUse demagnetizing tape.

General

System does not react when any button is pressed.

• Electrostatic discharge.

ªPress STANDBY-ON to switch the system off. Remove the AC power plug from the wall outlet, then reconnect the power plug and switch on the system again.

No or poor sound.

Volume is not turned up.

ª Adjust the volume.

The headphones are connected.

ª Disconnect the headphones.

Speakers are not connected or are connected wrongly.

ªCheck that the speakers are connected correctly.

ªMake sure the stripped speaker wire is clamped.

Reversed left and right sound.

Speakers are connected wrongly.

ª Check the speaker connections and location.

Lack of bass sound or apparently imprecise physical location of musical instruments.

Speakers are connected wrongly.

ª Check the speaker connection for proper phasing, red/black wires to red/ black terminals.

Remote control has no effect on the system.

• Wrong source is selected.

ªSelect the source (CD, TUNER, etc.) before pressing the function button,

(PLAY, PREV/NEXT, etc.).

The distance to the system is too large.

ª Reduce the distance.

Batteries are inserted incorrectly.

ªInsert the batteries with their polarities (+/– signs) as indicated..

Batteries are exhausted.

ª Replace the batteries.

Timer is not working.

Clock is not set.

ª Set the clock.

Timer is not switched on.

ªPress CLOCK/TIMER to switch on the timer.

Dubbing/recording is in progress.

ª Stop dubbing/recording.

Clock setting is erased.

There was a power failure.

ª Reset the clock.

System displays features automatically; buttons flash continuously.

Demonstration mode is switched on.

ª Press and hold (on the system) for 5 seconds to switch off the demonstration.

32

Image 32
Contents FW798W Warranty Verification Congratulations on your purchase, and welcome to the family Dear Philips product ownerAvis Set complies with the FCC-Rules, Part 15 and with 21 CFRClass Laser Product Safety Instructions Read before operating equipment Safety Instructions Audio System WHO is COVERED?Contents FM Wire Antenna Connection PreparationAM Loop Antenna Connection Speakers ConnectionRemote Control Wireless Surround Out ConnectionConnecting other Equipment to your system AC Power SupplySetting UP FB219W TransmitterActive surround speakers ConnectionsSetup PositioningPositioning the speakers General hints for positioningDolby PRO Logic Dolby Pro LogicTest Tone BalanceDolby Surround Dolby 3 StereoDolby Center Phantom Normal StereoControls StandbyonControls on the system and remote control Demonstration mode Sleep TimerControls Operating the System ShuffleSwitching the system on Switching the system to standby modeEasy Set Selecting the SourceMute on remote control only For neutral setting, select Classic and switch off DBBTo switch off DBB Loading the CD Changer Playing a CDDisc Change Discs for playbackSelecting a desired track Programming TracksReviewing the program Playing the programDisplay TunerPlayback Storing Preset Stations Tuning to Preset Radio StationsAutomatic programming Manual programmingWhen playback is stopped TapeTape Playback Loading a tapeWhen you release ˆor ‡, the tape continues playing There are two AUX modes Normal AUX modeSelecting External Equipment During playbackOnly Œ or ¶ mode is available during recording RecordingOnly on tape deck Press Tape Tape 12 to select tape deckCD Synchro Start Recording One Touch RecordingDigital Recording via Digital Out Dubbing will start immediatelyTimer Timer SettingClock Setting ClockTimer Sleep Timer Maintenance MaintenanceSpecifications SpecificationsTroubleshooting CD Player OperationRadio Reception Tape Deck OperationFB219W

FW798W specifications

The Philips FW798W is a notable entry in the world of compact audio systems, delivering a potent combination of robust performance, modern design, and versatile features. Designed with the audiophile in mind, this mini Hi-Fi stereo system is packed with advanced technologies that ensure superior sound quality and an enriching listening experience.

One of the standout features of the FW798W is its powerful output, capable of delivering dynamic sound that fills any room. The system often incorporates high-quality speakers that are engineered to produce clear highs, rich mids, and deep bass, creating an immersive audio environment for music, movies, and games alike. The overall design is compact yet sleek, allowing it to blend seamlessly into various home aesthetics while saving space.

The Philips FW798W is equipped with multiple sources for audio playback, including CD, FM/AM radio, and USB input, broadening its versatility. Users can enjoy their favorite CDs, listen to live radio broadcasts, or play music directly from their digital devices via USB, ensuring that one’s music library is always accessible. The system also features Bluetooth connectivity, allowing users to effortlessly stream music from smartphones, tablets, or other Bluetooth-enabled devices, making it even more user-friendly.

Moreover, the FW798W employs advanced audio technologies such as Digital Sound Control and Dynamic Bass Boost, which allow users to tailor their listening experience according to their preferences. Whether you prefer a more subdued sound profile or something with a punchier bass, these features ensure that you can manipulate the settings for optimal enjoyment.

The unit's user interface is designed with convenience in mind, often accompanied by a remote control that simplifies navigation through tracks and settings. A clear LED display provides essential information on tracks and radio stations, contributing to a more intuitive user experience.

In summary, the Philips FW798W stands out in the compact audio system market due to its impressive sound quality, extensive playback options, and user-friendly operation. Whether for casual listening or immersive experiences, this system caters to a variety of audiophile needs, making it a worthy addition to any home audio setup.