Philips FW798W manual Contents

CONTENTS
General Information	9
Safety Information	9
Preparation	10 - 11
Setting up FB219W	12 - 14
Dolby Pro Logic	14 - 15
Controls	16 - 18
Operating The System	18 - 20
CD	21 - 23
Tuner	23 - 24
Tape	25 - 26
AUX/CDR	26
Recording	27 - 28
Clock	29
Timer	29 - 30
Sleeptimer	30
Maintenance	30
Specifications	31
Troubleshooting	32 - 33

GENERAL INFORMATION

General Information

•The typeplate (which contains the serial number) is located at the rear of the system.

•Recording is permissible if copyright or other rights of third parties are not infringed.

•This device complies with part 15 of the Federal Communications Commission (FCC) rules. Operation is subjected to the following two conditions:

–This device may not cause harmful interference, and

–This device must accept any interference received, including interference that may cause undesired operation.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Acknowledgement

Dolby Pro-Logic and the double-D symbol

dare trademarks of Dolby Laboratories Licensing Corporation.

Manufactured under license from Dolby Laboratories Licensing Corporation.

Accessories (Supplied)

–Remote control

–Batteries (two AA size) for remote control

–AM loop antenna

–FM wire antenna

–AC power cord

–FB219W speaker package (includes one pair of wireless surround speakers and one center speaker)

Safety Information

•Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer. The typeplate is located at the rear of your system.

•When the system is switched on, do not move it around.

	SAFETY INFORMATION
•	Place the system on a solid base (e.g. a	English
	cabinet).
•	Place the system in a location with
	adequate ventilation to prevent internal
	heat build-up in the system.
•	The system incorporates a built-in
	safety feature that prevents
	overheating.
•	Do not expose the system to excessive
	moisture, rain, sand or heat sources.
•	Under no circumstances should you
	repair the system yourself, as this will
	invalidate the warranty!
•	If the system is brought directly from a
	cold to a warm location, or is placed in a
	very damp room, moisture may
	condense on the lens of the CD unit
	inside the system. Should this occur, the
	CD player will not operate normally.
	Leave the power on for about one hour
	with no disc in the system until normal
	playback is possible.
•	Electrostatic discharge may cause
	unexpected problems. See whether
	these problems disappear if you unplug
	the AC power cord and plug it in again
	after a few seconds.
•	To disconnect the system from the
	power supply completely, remove
	the AC power plug from the wall
	socket.
		9