How to keep a comfortable sharpness

3.Turn "OFF" the switch and store the trimming blade after operation. (Fig.16) Caution

Never place fingers on the upper side of the trimming knob. (The trimming blade will contact fingers at the time of storing.)

If the trimming knob is pushed downward with the trimming blade contacting fingers, storage will be impossible due to the disconnected lever.

Recommended

If the trimming blade cannot be stored, move the trimming knob upward and downward once or twice to restore it without forcibly pushing it in.

Maintenance

Never wash the power adaptor and LED light dryer with water. Also, never soak them in water or splash water on them. (Cause of electric shocks and short circuits)

Be sure to disconnect the power adaptor from the outlet and main body for maintenance. (Cause of electric shocks or injury)

Do not wash with water when using the shaver with AC. (Cause of short circuits)

Never push the blades strongly. (Cause of damage to skin especially lips or damage to the shaver.) Do not clean the foil-cutter assembly with the cleaning brush.

(Cause of deformation of the cutter or breakage of the foil)

After use (especially shaving with soap), make sure to perform maintenance. Make sure to wash the foil-cutter assembly with water.

Accumulation of beard clippings will cause deterioration in sharpness or scattering of beard clippings. For the main body and trimming blade, the cleaning brush can also be used.

Do not clean the foil-cutter assembly with the brush because doing so will cause deformation of the cutter or breakage of the foil.

After washing with water, apply the included shaver oil to the foil.

Smoothens rotation.	Prevents reduction in operating times.
Keeps sharpness.	Prevents blade heat generation.
Prevents blade wear.

Purchase optionally available shaver cleaner after the attached shaver oil is used up.

Cleaning with water

The foil-cutter assembly can be washed with water.

1.Turn "OFF" the switch to remove the cap and head holder. (Fig.17)

Remove the holder while pressing the head holder removal button.

Press the head holder removal button (1) to remove the head holder in the arrow (2) direction.

2.Turn "ON" the switch and pour water or lukewarm water between the foil assembly and main body for approximately 10 seconds to wash the foil and cutter assembly. (Fig.18)

Turn “ON” the switch. Advice

If buildup is severe or difficult to remove, wash with water, apply a small amount of kitchen detergent (neutral) to the foil, turn "ON" the switch, and evenly foam the entire surface of the blade for approximately 20 seconds. Then, wash the shaver once again to remove buildup. (Fig.19)

Foam for approximately 20 seconds.

If buildup still cannot be removed, remove the foil-cutter assembly, soak the shaver in water or lukewarm water containing a small amount of kitchen detergent (neutral) for approximately eight hours, then wash it with water to remove buildup. (Fig.20)

Please refer to "How to replace the foil-cutter assembly" to detach or attach the foil-cutter assembly. Never use bathroom or toilet detergents, etc.

Caution

Never turn "ON" the switch without pouring water on the blade and with the head holder removed. (Cause of scattering of hair clippings)

Never use hot water. (Cause of deformation and failure of the shaver) Never soak the main body in water. (Cause of failure of the shaver)

-8-