Mode indicator (Blue) |
| Light emitting lens |
|
Auto (flashing) Power (lighting), |
| Dry switch |
|
Normal (lighting off) |
| Each time the switch is pressed, it switches | |
Auto lamp (Green) |
| between ON and OFF. |
|
The auto mode operates to light |
| Lights during drying. |
|
the lamp. |
| Flashes slowly (at intervals of 2 seconds) | |
Remaining battery level indicator lamp | while the cutter is made to be | ||
The capacity of the battery is displayed | antibacterial. |
| |
by three lamps. When the "EMP" lamp | Flashes quickly (at intervals of 0.5 seconds) | ||
flashes during use, this indicates that | to indicate an error. |
| |
charging is required. |
| Catch |
|
|
|
| |
Charging completion lamp “ | ” | Attachment/detachment button | |
During charge: The lamp turns on. (Red) |
| ||
|
| ||
After charging is completed: The lamp | Charger socket |
| |
|
| ||
turns off. |
| Insert the plug for equipment of the power | |
|
|
| |
Main body |
| adaptor. |
|
|
|
| |
Center trimmer |
| Power adaptor : | |
|
|
| |
Swivels to securely catch beard. |
| Power plug |
|
|
|
| |
Trimming blade |
| Insert this into the outlet to its base. | |
|
|
| |
Used when a difficult to shave long beard | Plug for equipment | Cord | |
|
| ||
is shaved with the foil, or when |
| Cleaning brush |
|
|
|
| |
sideburns are closely trimmed. |
| Shaver oil | Pouch |
|
|
| |
Trimming knob : Slide this upward.
Comb
Guides long or rough beard into the foil.
LED light dryer (Included in the
Charging connector
Main body detection switch
The dry switch cannot be turned on unless the main body is set properly.
Preparation before use
How to charge
Charge before first use.
Make sure to use the included power adaptor for 100 - 240V AC power. You can also charge by using an LED light dryer.
The recommended charging temperature is in the range of 10 – 35°C
At a temperature below the recommended temperature, the charging response may slow down, causing an insufficient charge and a reduced number of operating times.
Each battery has a service life.
(The battery life greatly varies according to the conditions of use and storage.)
If the number of operating times is extremely small in spite of use in accordance with the instructions, it is considered that the battery life is about to expire. For battery replacement, consult with your distributor or customer service representative listed.
Never connect or disconnect to/from the outlet with wet hands. (Cause of electric shocks or injury) Avoid using in a place where water is splashed such as a bathroom or in a place with high moisture. (Cause of electric shocks or short circuits)
Wipe away water drops on the main body sufficiently to dry it before charging. (Cause of burns due to short circuits and heat generation)
1. Turn "OFF" the switch and connect the power adaptor to the main body and outlet. (Fig.2)
Turn “OFF” the switch. 
Connect by aligning the (+) and
Charging completion lamp
During charge: The lamp lights (red).
After charging is completed: The lamp turns off.