Hitachi rm-ltx7000dy manual Troubleshooting

1.Turn "OFF" the switch to remove the cap and head holder. (Fig.17)

Press the head holder removal button (1) to remove the head holder in the arrow (2) direction.

2.Detach the foil-cutter assembly. (Fig.28)

Slide the foil-cutter assembly detaching knob to the right (1),pick up and pull both ends of the foil-cutter assembly straight upward (2) to detach it.

Never pull it diagonally, otherwise, it may not be detached.

3.Press the lower part of the head holder removal button to attach a new foil-cutter assembly. (Fig.29)

Alignment mark( )	Alignment mark( )
Align the alignment marks (	) and ( ) of the foil-cutter assembly and main body.

Push down the both ends of the foil-cutter assembly until it clicks.

Alignment mark

Caution

Floating of the foil-cutter assembly will result in failure.

The foil-cutter assembly cannot be connected in a state where it is facing back to front.

4.Confirm the attachment of the foil-cutter assembly. (Fig.30)

Pick up and lightly pull both ends, and if the assembly cannot be removed, it is properly attached.

5.Press the lower part of the head holder removal button to attach the head holder. (Fig.21) Align the front face of the head holder to the switch side for attachment.

Caution : The head holder cannot be connected in a state where it is facing back to front.

Troubleshooting

Before requesting repair, check the following:

	Symptom	Check point	Remedy
-	Hot blade surface	Check to see if the outer-inner	Push in the outer-cutter
-	Deterioration in	blade assembly is securely	assembly until it clicks allowing no
	sharpness	attached (not floating).	gap to the main body.
-	Weak rotation
		Check for heavy accumulation	Periodically perform maintenance.
-	Small number of	of beard clippings inside the
	operating times	blade.
-	Stop during use
		Check the blade surface for oil
		shortage.
-	Scattering of beard	Check for accumulation of beard	Periodically perform maintenance.
	clippings with the	clippings.
	switch “ON”
		Check for insufficient
-	Strong smell
		maintenance.
-	Charging completion	Check for full charge.	There is no problem.
	lamp turns off early		Use as is.
-	Remaining battery	Check for being not in use for 3	Charge when the remaining battery
	level indicator lamp	months or more.	level indicator lamp “EMP” flashes to
	flashes early		indicate that charging is required.
-	No movement with	Check for being out of charge.	- Turn “OFF” the switch, and charge
	the switch “ON”	Check for accumulation of beard	for approximately 1 minute before
		clippings.	use.
		Check the blade surface for oil	- Disconnect the power adaptor
		shortage.	once, and insert it again.
			- Periodically perform maintenance.
-	Failure of charging	Check to see if the power	Check to see if the power adaptor is
	with the LED light	adaptor is properly connected.	properly connected.
	dryer	Check to see if the main body is	Check to see if the main body socket
		properly set to the LED light	is properly set in the charging
- No movement of the
	LED light dryer (dry	dryer.	connector. Reset the main body.
	switch flashing
	quickly)

-11-