Do not remove the main body during drying (when the inscription
5.After completion, take out the main body, and disconnect the power adaptor from the outlet. Caution : Never wash the LED light dryer with water. (Cause of failures)
6.After drying, apply the shaver oil, and keep it in a place free from moisture.
After drying, apply the shaver oil and store in a in a place free from moisture. For details, see 5 and 6 under “Maintenance (Cleaning with water).”
■To deliver full performance of the lithium-ion battery
If you do not use the shaver for 3 months or more, discharge until the remaining battery level indicator lamp “EMP” flashes, and then charge for approximately 45 minutes.
Brush cleaning
Never clean the
Otherwise, the cutter will deform to damage the foil, or the brush tip may be caught in the foil.
1.Turn "OFF" the switch and detach the head holder and the
Please refer to "How to replace the
2.Clean the main body and trimming blade. (Fig.25)
3.After cleaning, store the trimming blade, attach the
Recommended
Once a week, turn "ON" the switch, apply of the included shaver oil to the foil and trimming blade, and after 4 to 5 seconds, turn "OFF" the switch, and wipe the surfaces of the foil and trimming blade with tissue, etc.
Remove contamination on the main body with a cloth which contains water or diluted kitchen detergent (neutral) and firmly wrung.
CAUTION
Never use alcohol, benzine, and thinner, etc. (Causes of deformation and discoloration)
Maintenance of the LED light dryer (Included in the
The LED light dryer cannot be washed with water. Caution
Make sure to disconnect the power adapter from the LED light dryer.
Do not tilt the LED light dryer or turn it upside down.
(Cause of spillage or internal entry of water droplets having accumulated in the catch)
1. Clean the catch. (Fig.26) 
Remove while pushing the attachment/detachment buttons.
Remove the catch by pushing the attachment/detachment button. Be careful not to tilt it if water has accumulated.
Pour out the water, and lightly wipe with a dry cloth or tissue, etc. Caution
When removing the catch, if the LED light dryer is turned upside down, water droplets may enter the inside,
After maintenance, attach the catch.
2.Clean the inside. (Fig.27)
Lightly wipe away dust, dirt, etc., adhered to the light emitting lens and the inside with a cloth or tissue, etc., moistened with water.
Clean the corners and projections and depressions with a cotton swab, etc.
How to replace the foil-cutter assembly
When replacing the
Never strongly hold the
After blade replacement, make sure to apply the included shaver oil. For spraying places, see 5 under “Maintenance (Cleaning with water).”
(Cause of failure of movement of the cutter or heat generation of the blade surface)