Usage Tips
Charging
Prior to using your shaver for the first time, put it on charge for 24 hours.
To charge your shaver:
■Make sure your shaver is turned off.
■Connect the cord to the shaver and then the charging adapter to the electric outlet. A charging indicator light will come on.
■Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves.
■Use only the charging adapter supplied with the shaver.
■
Model R-450s/650s
A green indicator light shows when the shaver is charging.
Troubleshooting:
■If your shaver battery is completely
If this condition occurs, charge the shaver for approximately five minutes before shaving.
8
■Your cord/cordless shaver should not be used strictly as a cord- operated shaver, as continued cord only use will result in reduction of battery life.
■In order to preserve the life of the batteries, they should be fully discharged every six months and then fully charged for 24 hours.
Worldwide Voltage (R-650s Microflex® Model)
You can take your shaver with you when you travel to just about anywhere in the world. Your shaver features worldwide automatic dual voltage conversion providing AC current between
Battery Removal:
When your rechargeable shaver reaches the end of its useful life, the batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements.
THE FOLLOWING PROCEDURE SHOULD BE FOLLOWED FOR BATTERY REMOVAL:
■To avoid a possible electric shock hazard,
unplug cord from electric outlet and shaver.
■Open the head
assembly by
pressing the head 
release buttons and lifting the
head assembly. Pull the entire
head assembly off of the shaver
assembly.
■ Push the trimmer button up to open the trimmer.
■ Remove the trimmer assembly by squeezing the sides as shown in the picture.
■Using a small Phillips head screwdriver, remove the 3 screws from the back of the shaver.
■Pull or gently pry the shaver halves apart, exposing the battery.
■Pry the lower battery clip off.
■Lift or pry the batteries out of the shaver.
■Cut the wires on both ends of each battery and remove them from the shaver.
CAUTION: DO NOT PUT IN FIRE OR MUTILATE YOUR BATTERIES WHEN DISPOSING AS THEY MAY BURST OR RELEASE TOXIC MATERIALS. DO NOT SHORT CIRCUIT AS IT MAY CAUSE BURNS. DISPOSE PROPERLY IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS.
9
5/24/07 11:05:07 AM