Micro Technic 81781, 81791 user manual

Page 7

3.Route the sensor pad cable from the sensor pad to the control unit. The cable will need to run from the top of the mattress to the underside of the bed and up the headboard, footboard, or rail of the bed (Figure 4). Make sure the cable lies freely and does not interfere with handrails or moving parts of the bed.

4.Mount the control unit on the bed headboard, footboard, or rail in a convenient location using the mounting strap or mounting bracket. Optional wide mounting brackets are available for extra wide headboards and footboards.

5.Insert the sensor pad cable into the sensor pad receptacle on the control unit.

6.If you are using the Informer-MateDeluxe system, set the desired alarm tone by sliding the volume switch to position 1, 2, 3 or 4. If connecting a nurse call cable to the deluxe unit, the alarm will, when sounding, automatically be sent to the nurse call unit and the local alarm will be disabled.

7.Test the Informer-Matemonitoring system before each use and inspect the pads and monitor regularly to make sure they are not damaged. Test the system by pressing firmly on the pad for 3 seconds. When you remove pressure, the alarm should sound. Reset the alarm using the 2-button reset.

4

Image 7
Contents 0163-198-G Informer-MateTMModel 81781 Informer-MateTMDeluxe ModelPage Page Monitor Design Battery Installation Alarm Mode Switch SettingsInstalling the Informer-MateSystem on a Bed Page Installing the Informer-MateSystem On a Chair To keep your sensor pads in good condition MaintenanceWarranty and Disclaimer Monitors Micro-TechAccessory & Replacement Items