Transfer From Wheelchair
1.Grasp the sling at each corner of the "U" shape of the commode aperture.
2.The sling should be fitted with the handle on the back section facing outward.
3.Help the user lean forward slightly, then slide the sling down between the chair and the user's back.
4.Position the commode aperture where the buttocks meets the seat.
5.Position the sling equally around both sides of the body.
6.Draw the leg sections to the front along the length of the user's thigh.
7.Check the sling's central positioning by comparing the lengths of the leg sections when they are drawn forward.
8.Reposition the sling if the leg sections are not equal in length.
9.Feed the leg sections under the thighs.
10.From between the legs, gently pull the leg section up the inner thigh.
11.Feed as much material as possible under and between the thighs. Ensure the leg sections are positioned midway under the thighs to provide good support and greater comfort.
12.Move the lift slowly towards the user and position the spreader bar over the user's chest.
13.Attach Loop a of sling to Hook A on Spreader Bar; attach Loop b to Hook B; attach Loop c to Hook C; attach Loop d to Hook D.
14.Lift patient above the wheelchair by using the hand control.
15.Pull lift away from wheelchair. Position patient over bed and lower patient onto it.
Note: Reverse the above procedures when returning the user/patient to a wheelchair.
Warning: Use ONLY Lumex slings/products with Lumex equipment.
LF1050 Patient Lift Owner’s Manual | 11 |