trimmer |
dry |
trim |
mer |
on |
Series | Series |
| |
release |
|
er |
oil |
Series 7 |
release |
click! |
Series 7 |
release |
trimmer |
Series 7 |
release |
| Series 7 |
release | release |
Cleaning
Automatic cleaning
After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section «Before shaving».
All charging and cleaning needs are then automatically taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles.
The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks.
The cleaning cartridge also contains lubricates, which may leave residual marks on the outer foil frame after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper.
Manual cleaning
The
Rinsing the shaver head under running water is an alternative way to keep the shaver clean, especially when travelling:
•Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
•Next, switch off w the shaver, press the release button 9 to remove the foil and cutter cassette 8 and let it dry.
•If you regularly clean the shaver under water, then once a week apply a drop of light machine oil on top of the foil and cutter cassette.
Alternatively, you may clean the shaver using the brush provided:
•Switch off w the shaver. Remove the foil and cutter cassette 8 and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. However, do not clean the cassette with the brush as this may damage it.
10