Braun 7540 manual Description, Charging the shaver, Indicator lights, Technical specifications

English

7540

0

1

2

+35°C

+15°C

7540

4

Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver.

Important

Only use the power supply cord set provided. A damaged cord must be replaced immediately.

Description

1	Foil protection cap	7	Charging lights
2	Shaver foil		(green)
3	Cutter block	8	Low-charge light
4	Foil release button		(red)
5	Long hair trimmer	9	Pilot light
6	Switch	10	Shaver socket

Technical specifications:

•Wattage via cord set: 7 W

•Power supply via cord set: 100-240 V 2/50 or 60 Hz (automatic adaptation)

•Shaver input voltage: 12-24 V

Charging the shaver

•First charging: Using the power supply cord set, connect the shaver to the mains with the switch on position «0» and charge it for at least 4 hours (plug might get warm).

•Once the shaver is completely charged, shave without the cord until fully discharged. Then recharge to full capacity again (subsequent charges will take about

1hour).

•A full charge will give up to 50 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.

•Best environmental temperature range for charging is

15°C to 35 °C.

Indicator lights

•The pilot light shows that the shaver is connected to the mains.