Braun RA200 Controller to Vehicle Connections 929.505-3 Amp Connector, User Inputs/Outputs

Installation Instructions

User Inputs/Outputs

The weight sensor controller has five required user inputs and five optional user outputs. At least four user inputs are required to be connected in order for the ramp to function, whereas none of the user outputs must be connected (optional).

Below is a list of the user inputs and outputs, including the designated connector pin number, wire color, and description. Please note the optional user outputs have maximum limitations as specified in the “Restrictions” column below.

Controller to Vehicle Connections (929.505-3 Amp Connector)

Function	Pin #	Wire Color	LED	Description	Restrictions
Input (Pulse)	1	Black	LD10	Ramp Enable	Required
Input (Pulse)	2	Brown	LD11	Ramp Operate	Required
Input (Continuous)	3	Red	LD12	Door Full Open	Required
Input (Pulse)	4	Orange		Reset Controller	Optional
Power Supply	5	Yellow		+24 V Supply	10 A Time Delay Fuse
Power Ground	6	Blue		Ground	Required
Input (Pulse)	7	Violet/Yellow	LD13	Close All Doors	Required
Input	8	Violet/Green	LD14	Extra	Optional

All Connections on this Connector Optional (929.505-6 Amp Connector)

Function	Pin #	Wire Color	LED	Description	Restrictions
Input	1	Green		Relay Power (+24 V)	10 A Time Delay Fuse
Output	2	Purple		N.C. Ramp Enabled
Output	3	Grey	LD17	N.O. Ramp Enabled	Required
Output	4	White		N.C. Open Door
Output	5	Black/White	LD18	N.O. Open Door	Required
Output	6	Black		N.C. Ramp Malfunction
Output	7	Red/White	LD19	N.O. Ramp Malfunction
Output	8	Orange/Red		N.C. Clear Signal
Output	9	Yellow/White	LD20	N.O. Clear Signal	Required
Output	10	Blue/White		N.C. Manual Release Unlocked
Output	11	Green/White	LD21	N.O. Manual Release Unlocked
Output	12	Red/Black	LD22	N.O. Ramp alarm
Power Ground	13	Gray/Pink		Ramp alarm ground
Not Used	14
Not Used	15
Not Used	16
Not Used	17
Not Used	18

Ramp to Controller Connections (T1730-S14 Thomas & Betts Connector)

Function	Pin #	Wire Color	LED	Description	Restrictions
Input	1	Yellow/Red	LD6	Pressure Mat Return
Power	2	Green/Black		Ramp + 24 V
Power	3	Orange/Black		Ramp Ground
Input	4	Orange	LD1	Ramp full out sensor
Input	5	Green/Black	LD2	Ramp full in sensor
Output	6	Red/White	LD29	Drive Motor +
Output	7	Yellow	LD30	Drive Motor -
Input	8	Blue	LD3	Ramp full up sensor
Input	9	Yellow	LD4	Ramp full down sensor
Not Used	10
Not Used	11
Input	12	Brown	LD5	Ramp manual release sensor
Output	13	Black/Red	LD27	Elevate motor +
Output	14	Orange/Red	LD28	Elevate motor -

Page 7