Philips T510 warranty Features, Cleaning, Replacing The Cutting Unit

Features

APatented AccuControl System with Removable Guide Comb Attachment

BSelected Hair Length Setting Window

C4 Length Settings

D3-Dimensional Rounded Chromium Steel Cutter Blades

EOn/Off Switch

FCleaning Brush

Full Two-Year Warranty

60-Day Money-Back Guarantee

Trimming Length Settings Table

Settings		Resulting beard length
#1	“Stubble” Setting	.06 in./1.5 mm
#2	Short	.12 in./3 mm
#3	Medium	.2 in./5 mm
#4	Long	.28 in./7 mm

Trimming For “Stubble” Look

1Be certain Guide Comb is on Trimmer and use setting #1 to result in a “stubble” look. (fig. 9).

Trimming Without Guide Comb Attachment

Remove Guide Comb Attachment if you are:

◗Defining hair lines

◗Trimming nape of neck

◗Removing single, unwanted hairs

1Be certain Trimmer is in the OFF position.

2Remove the Guide Comb Attachment by adjusting it to setting #4 and then pulling it off the Trimmer (fig. 10).

Never pull off the Guide Comb Attachment by grasping the flexible top portion. Always pull off by the bottom part of attachment.

3Switch the Trimmer ON.

4Make well-controlled movements.Touch the hair lightly with the Trimmer (fig. 11).

Replacing Guide Comb Attachment On Trimmer

1Be certain Trimmer is in OFF position.

2Replace Guide Comb Attachment until

it “clicks” into position and adjust comb to the chosen setting.The Guide Comb Attachment can be placed on Trimmer only one way. If it does not fit properly, reverse it.

Cleaning

◗Always switch Trimmer OFF before cleaning.

◗Do not use abrasives, scourers or liquids such as alcohol, benzene, bleach or acetone to clean the Trimmer.

◗Never clean, remove or replace Guide Comb Attachment with motor ON.

◗Do not apply pressure to cutters.

◗Do not touch cutters with hard objects as this may damage them.

◗Do not use while bathing, showering or immerse the Trimmer in water or other liquids as damage to Trimmer may occur.

During Use:

◗If cut hairs have accumulated in the Guide Comb area, turn Trimmer off, remove the Guide Comb Attachment by adjusting it to setting #4 and then pull it off Trimmer. Remove hairs by shaking and/or blowing.

Once A Week:

1Make sure the Trimmer is switched OFF.

2Remove the Guide Comb Attachment.

3Open the cutting unit by pushing it backwards (fig. 12 #1).

4Clean the cutting unit and the inside of the Trimmer with the brush supplied (fig. 12 #2).

5Close the cutting unit by pushing it back into place on the Trimmer until you hear a click (fig. 13).

Replacing The Cutting Unit

If your cutters become damaged or worn, do not continue using the Trimmer. Replace cutters immediately.

1Open the cutting unit.

2Remove the old cutting unit by pulling it upwards.

3Place the two notches of the new cutting unit into the guiding slots (fig. 14 #1).