Philips 7800XLCC manual After Each Use Trimmer, Cleaning the Jet Clean Canister

24ENGLISH

C 2	Press the Razor Head Release Button, flip
	open the Razor Head Assembly.
C 3	Clean inside razor heads and hair chamber
	by running under hot water.

C 4	Clean outside of Razor Head Assembly by
	running under hot water.
5	Close the Razor Head Assembly and shake
	off excess water.
C 6	Open Razor Head assembly again and
	leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue.This could damage the
shaving heads.
C 7	If the shaving unit becomes detached from
	the razor, you can easily reattach it.
8	You may also clean the hair chamber
	without water by using the supplied brush.

ENGLISH 25

After Each Use: Trimmer

1Turn razor OFF.

		Push down spring-release trimmer switch.
	2
C		Clean trimmer with the brush every time
	3
C		you use it.
		Lubricate the trimmer teeth with Philips
	4
		Norelco Razor Lubricant (modelAL80) or
		with one drop of mineral oil every 6 months.
		Close trimmer by pressing trimmer down.
	5

This razor and Jet Clean System have no other user- serviceable parts. Any other service should be performed by the Philips Norelco Service Location.

Cleaning the Jet Clean Canister

For optimal performance of the Jet Clean System,it is recommended that you empty the cleaning solution canisterand thoroughly rinse the canister clean every 2 weeks.

1Place the Jet Clean System on a flat, level surface.

C 2 Simultaneously press the buttons located on both sides of the Jet Clean System (1) and lift the appliance off the Jet Clean canister (2).

Always remove appliance from canister by lifting straight up. Do not tilt Jet Clean System.