Charge Meter, Before First Use, Charging

16ENGLISH

Charge Meter

◗Charge Meter monitors amount of remaining battery power and actual remaining shaving minutes available. ‘Minutes Left’ is based on the amount of power consumed shaving per minute and is dependent upon your skin and beard type, whether you use pre-shave lotion, and how often the trimmer is used.

◗Initially your razor may need to go through 2 or 3 full charge/recharge cycles before “Minutes Left” indicator (numeric or battery) begins to display your accurate“Shaving Minutes Left.”

Before First Use

◗Charge the razor before you start using it (see ‘Charging’). Make sure the razor is switched off before you start charging it.

◗Remove any sticker or protective foil from the LCD Display before using razor.

Important

◗Only use the power plug and/or Jet Clean System provided to charge the razor.

◗The charging plug converts 100 – 240V AC to less than 24V DC.

ENGLISH 17

Charging

◗Battery performance is best if you recharge only when the batteries are (almost) completely empty.

◗Charging or recharging at temperatures below 40ºF or higher than 95ºF adversely affects lifetime of batteries.

◗Continuously recharging or continuously using as a corded razor will reduce life of batteries.

◗You may also shave using the cord provided. This razor will not recharge while being used corded.

◗Do not charge razor in a pouch.

◗Recharge only when the plug symbol starts blinking.This symbol may appear when your razor is ON or OFF.

◗Do not charge/recharge or use razor corded until fully dried.

Charging Razor with a Cord

C 1 Connect cord directly to razor and connect the charging plug into any 100V to 240V AC outlet. Use only the charging plug provided.

◗An adaptor plug may be necessary for charging plug usage in some foreign countries. Use an attachment plug adaptor of the proper configuration for the power outlet.

The charging plug will automatically convert to work on 100V to 240V AC systems.