28ENGLISH
C 5 Press the ON/OFF button to start the cleaning cycle.
The cleaning light on the Jet Clean System starts blinking and the razor is automatically lowered into the cleaning solution.The razor stops charging while it is cleaning.
◗During the first few minutes of the cleaning cycle, the razor will automatically turn on and off several times while the razor holder lowers and raises the razor’s position in the cleaning solution, removing all debris.
◗After approximately 5 minutes, the razor holder will be raised slightly and will stay in this position for about 55 minutes.The cleaning light will remain blinking until the entire process is complete.
◗Do not lift the razor lever or press the ON/OFF button while the cleaning cycle is running. If this does occur, the cleaning cycle will stop and the razor holder will automatically move to the highest position. The cleaning cycle can be
◗If the power plug is disconnected before the cleaning cycle is complete, the razor holder will remain in its current position. Reconnect the plug into the outlet or Jet Clean System and the razor holder will automatically move to the highest position. The cleaning cycle can be
| ENGLISH 29 |
C 6 | When the entire cleaning cycle is complete |
| and the razor is hygienically clean, the razor |
| will be raised to the highest position and |
| the cleaning light on the Jet Clean System |
| will light up continuously. |
C 7 | Raise the lever holding the razor to the |
| highest position (1) and carefully remove |
| the razor from the Jet Clean System (2). |
◗You may quickly rinse the razor heads with warm water after using the Jet Clean System to remove any residual cleaning solution.
◗If the razor needs to be recharged, you can simply leave it in the Jet Clean System after cleaning and the razor will automatically recharge.The charging light on the Jet Clean System will blink to indicate the razor is recharging.
◗For optimal razor drying time after cleaning, remove razor from Jet Clean System after the cleaning cycle is complete and allow to air dry.
◗You may store your razor in the Jet Clean System. Unplug from the outlet when charging/cleaning is complete.
Quick Cleaning: Razor Heads
The razor heads may also be quickly cleaned after each use by rinsing with hot water. Water from the tap should be on a hot setting, BUT BE CAREFUL TO TEST WATER FIRST SO AS NOT TO BURN OR SCALD HANDS.