Sentry Industries Sentry Xpress 4.0 manual Shorthand Instructions, Single-Speed

Page 16

Shorthand Instructions

These instructions may be confusing until you have read more detailed instructions on Single-Speed, page 6, or Ramp-Hold, page 8. Read the safety guidelines, page 3. After pressing the keys in left column, the center message will appear.

Single-Speed

Keys to Press

Display

 

thru

(Not Down Arrow) Select rate

(Sample rate)

 

or

Enter temperature

(Sample temperature)

Enter hold time

(Or hold time)

 

The kiln is now firing.

Ramp-Hold

Keys to Press

Display

 

thru

(Not Down Arrow)

Select Program #1, 2, 3, or 4

Enter Segment 1 rate

(Sample rate)

 

or

Enter Temperature

(Sample temperature)

Enter Hold Time

(Or hold time)

First segment not needed: enter a rate of 0000.

The kiln is now firing.

16 Single-Speed/Ramp-Hold

Image 16
Contents Sentry Xpress Contents IntroductionSafety Time and Temperature DisplayGeneral Guidelines Operation Begins from the IdLE DisplayDelay Power FailuresThunder Storms Power Surges Canceling a New ProgramTheory Operation RateHold Two Firing Modes Single-Speed and Ramp-HoldSelecting a Firing Mode Temperature Over-ShootSingle-Speed Programming Instructions Ramp-Hold Mode Programming a Cooling SegmentRamp-Hold Practice Program Parts of a SegmentAdvanced Features Skip SegmentAdd Hold Time Ramp-Hold Programming InstructionsEditing the Target Temperature AlarmLost Wax Burnout OverviewDisplay Messages Burnout InstructionsError Messages BAdP / Bad ProgrammingEtH / Electronics Too Hot Fail / Thermocouple FailureFE Error Messages HtdE / High Temperature DeviationPF 1 / Power Failure PF 2 / Power FailureProblem Controller display is blank. No heat in kiln Controller Power Input TestSelecting F or C Display Trouble ShooterProblem Controller display turns on. No heat in kiln Kiln Switch Box ½ Amp Fuse Power Test Problem Kiln switch box ½ amp fuses keep blowingIndex Shorthand Instructions Single-Speed