Wayne-Dalton 346918 installation instructions 6100, B l e O f C o n t e n t s

Page 1

6100

T o r s i o n

Standard Lift

MH

installation instructions and owners manual

GARAGE DOORS & OPENERS

T a b l e O f C o n t e n t s

Parts Breakdown

2

Pre-Installation

3

Important Safety Instructions

3

Tools Required

3

Package Contents

3

Door Section Identification

4

Removing an Existing Door

4

Preparing the Opening

4

Installation

6

Optional Installation

15

Door Arm Hookup

15

Inside Lock

15

Pull Down Rope

15

Maintenance

16

Cleaning Your Garage Door

16

Painting Your Garage Door

16

Operation and Maintenance

16

Warranty

18

Dealer Locator Information

20

IMPORTANT NOTICES!

Wayne-Dalton highly recommends that you read and fully under- stand the Installation Instructions and Owner’s Manual before you attempt this installation.

To avoid possible injury, read the enclosed instructions carefully before installing and operating the garage door. Pay close attention to all warnings and notes. After installation is complete, fasten this manual near garage door for easy reference.

The complete Installation Instructions and Owner’s Manual are available at no charge from:

Wayne-Dalton, a Division Of Overhead Door Corporation, P.O. Box 67, Mt. Hope, OH., 44660,

Or Online At www.Wayne-Dalton.com

©Copyright 2012 Wayne-Dalton, a Division Of Overhead Door Corporation

Part No. 346918

REV6_03/01/2012

Image 1
Contents B l e O f C o n t e n t s 6100Representations of the door parts. Each specific door Important Safety Instructions Tools Required Lock Section can be identified by #2 graduated end hinges Attempt is made to start removing an existing doorFound not to be sound, must be replaced Mounting surface with nailsRadius track 14-1/2 368 mm 12-1/2 318 mm LHR Kit 229 mm Headroom RequirementsPage Pull Handles Lift HandlesTools None Vertical Tracks Bottom SectionStacking Sections Level, Step ladderStrut A-symmetrical Top FixturesDrawbar Operator Bracket Horizontal Tracks/Q.I. Flag Angles Top SectionHorizontal Tracks/F.A. Flag Angles End Bearing BracketsTorsion Spring Attachment Center Bracket Bushing AssemblyTape measure, Pencil Tools Step LadderCounterbalance Lift Cables Securing Door for Spring WindingsWinding Springs This manual Rear Back HangsCheck the door for level To 7/8 16 Bolts and nuts Perforated angleInside Lock Door Arm HookupPull Down Rope Wood Maintenance and Refinishing Touch up where necessaryFollowing cleaning solution is recommended Use in general cleaning of garage doorsPage Lifetime Limited Warranty Model Warranty