Wayne-Dalton 346918 installation instructions

Page 17

WARNING

NEVER REMOVE, ADJUST, OR LOOSEN THE BOLTS, SCREWS AND/OR LAG SCREWS ON THE COUNTERBALANCE (END OR CENTER BEARING BRACKETS) SYSTEM OR BOTTOM BRACKETS OF THE DOOR. THESE BRACKETS ARE CON- NECTED TO THE SPRING(S) AND ARE UNDER EXTREME TENSION. TO AVOID POSSIBLE SEVERE OR FATAL INJURY, HAVE ANY SUCH WORK PERFORMED BY A TRAINED DOOR SYSTEMS TECHNICIAN USING PROPER TOOLS AND INSTRUCTIONS.

Torquemaster® Plus Springs: Pawl knob(s) (located on the TorqueMaster® end brackets above the door) should be engaged to prevent the door from rapidly descending in case of spring failure or forceful manual operation.

Torsion Springs: The torsion springs (located above the door) should only be adjusted by a trained door systems technician. DO NOT attempt to repair or adjust torsion springs yourself.

Extension Springs: A restraining cable or other device should be installed on the extension spring (located above the horizontal tracks) to help contain the spring if it breaks.

2.Door Balance: Periodically test the balance of your door. If you have a garage door opener, use the release mechanism so you can operate the door by hand when doing this test. Start with the door in the fully closed position. Lift the door to check its balance. Adjust Torquemaster® or Extension spring(s), if door lifts by itself (hard to pull down) or if door is difficult to lift (easy to pull down). DO NOT attempt to repair or adjust Torsion Springs yourself. To adjust Torquemaster® or Extension spring(s), refer to your installation instructions and owner’s manual. If in question about any of the procedures, do not perform the work. Instead, have it adjusted by a trained door systems technician.

3.Lubrication: The door should open and close smoothly. Ensure the door rollers are rotating freely when opening and closing the door. If rollers do not rotate freely, clean the door tracks, re- moving dirt and any foreign substances. Clean and lubricate (use a non-silicon based lubricant) hinges, steel rollers and bearings. DO NOT lubricate plastic idler bearings, nylon rollers, door track. DO NOT oil a cylinder lock, if actuation is difficult use a graphite dust to lubricate.

17

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,

refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Page 16 Page 18
Image 17
Page 16 Page 18
Contents B l e O f C o n t e n t s 6100Representations of the door parts. Each specific door Important Safety Instructions Tools Required Lock Section can be identified by #2 graduated end hinges Attempt is made to start removing an existing doorFound not to be sound, must be replaced Mounting surface with nailsRadius track 14-1/2 368 mm 12-1/2 318 mm LHR Kit 229 mm Headroom RequirementsPage Tools None Lift HandlesPull Handles Vertical Tracks Bottom SectionStacking Sections Level, Step ladderDrawbar Operator Bracket Top FixturesStrut A-symmetrical Horizontal Tracks/Q.I. Flag Angles Top SectionHorizontal Tracks/F.A. Flag Angles End Bearing BracketsTorsion Spring Attachment Center Bracket Bushing AssemblyTape measure, Pencil Tools Step LadderWinding Springs Securing Door for Spring WindingsCounterbalance Lift Cables Check the door for level Rear Back HangsThis manual To 7/8 16 Bolts and nuts Perforated anglePull Down Rope Door Arm HookupInside Lock Wood Maintenance and Refinishing Touch up where necessaryFollowing cleaning solution is recommended Use in general cleaning of garage doorsPage Lifetime Limited Warranty Model Warranty
Top Page Image Contents