Lifescan Blood Glucose Monitor manual Operation, Coding the Meter

Page 27

CHAPTER 2

Operation

Coding the Meter

The SureStep Meter is calibrated at the factory. Although an internal verification is performed each time the meter is turned on, a system calibration (meter and test strip) is necessary. This is achieved at the start of each test when you enter the code number for the current bottle of test strips.

Each time you test or when you open a new bottle of test strips, check that the code number on the meter matches the code number on the test strip bottle. If the meter code does not match the code on the test strip bottle, change the meter code.

O p e r a t i o n 17

Image 27

Contents Hospital Meter Operator’s Guide Page Page 2002, 1997 LifeScan, Inc. All rights reserved Table of Contents Settings and Memory Cleaning and MaintenanceTroubleshooting Preface About this Guide Conventions Used in this Guide 888 353-0800 Canada HelpIntroduction Learning the SureStep Meter IntroductionClosed Opened Display Symbols Meter Memory Result Apply Blood Sample to the Test Strip Meter displays results between 0-500 mg/dL 0-27.8 mmol/L HI Result Error Messages SureStepPro Test Strips Front Back H a p t e r T r o d u c t i o n Precautions T r o d u c t i o n Infection Control Coding the Meter OperationOperation If the code numbers do not match, code the meter Match the code numbersQuality Control Test Glucose Control Solution Operation Performing a Quality Control Test Check the CodeCha pt e r E r a t i o n H a p t e r E r a t i o n Control Solution Results Linearity Test Patient Blood Test Performing a Patient Blood Test Apply blood to the test strip as follows Obtain a drop of bloodSyringe Front Patches or streaks H a p t e r E r a t i o n Patient Results Meter Settings Settings and MemorySettings and Memory Display of Last Result Glucose Units Beep signals on Meter Memory Using the Meter for the First TimeRecalling All Results in Meter Memory Order of test result Recalling Most Recent Result After Testing Settings and Memory General Care Cleaning MaintenanceCleaning Cleaning and MaintenanceCleaning the Outside of the Meter Remove the test strip holder Clean the test strip holderE a n i n g a n d M a i n t e n a n c e Replace the test strip holder Turn on the meter H a p t e r Turn off the meter and turn it over Replacing the BatteriesRemove the old batteries Replace the battery door Turn on the meter to verify powerInsert new batteries Cleaning and Maintenance Troubleshooting Troubleshooting What To Do Error MessagesLow Test strip Check test strip Test strip Obtain a laboratory Result, Area, but Temperature Contact LifeScan for help Electronics Helpful Messages Symbol Meaning What To DoIf symbol is Specifications Hematocrit Range Index Error messages 9 Page Page AW 050-097-03A LifeScan, Inc 11/02

Related manuals

Manual 74 pages 3.73 Kb