Alpine Comprehensive Guide for Installing and Removing the CDA 7892 CD Player

Installation

Metal plate

Detachable

Front panel

Caution

When you install this unit in your car, do not remove the Detachable Front Panel.

If the Detachable Front Panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.

1	Mounting Sleeve
	(Included)

Dashboard

CDA-7995/CDA-7894/CDA-7893/CDA-7892

Slide the mounting sleeve into the dashboard.

2	Screw
	Hex Nut (M5)

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the CDA-7995/CDA-7894/CDA-7893/CDA-7892. Connect all other leads of the CDA-7995/CDA-7894/CDA- 7893/CDA-7892 according to details described in the CONNECTlONS section.

3

Lock Pin

Slide the CDA-7995/CDA-7894/CDA-7893/CDA-7892 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

Removal

1Remove the DETACHABLE FRONT PANEL.

2Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

∗∗

Metal
Mounting
Strap	∗

Ground Lead

Chassis

Bolt Stud

CDA-7995/

CDA-7894/

CDA-7893/

CDA-7892

CDA-7995/ CDA-7894/ CDA-7893/ CDA-7892

Face Plate

Screws (M5 ⋅ 8) (Included)

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.

NOTE

For the screw marked **, use an appropriate screw for the chosen mounting location.

Ground Lead

∗

Mounting Bracket

NOTE

Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.

37-EN