Wall mount preparation
To mount the unit on the wall
Caution:
●Be very careful to prevent the unit [2.45 kg (5.4 lbs.)] from falling when mounting on the wall.
●Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The unit may fall.) If unsure, consult a qualified service technician.
●Mounting screws are not supplied. Use appropriate ones.
●Check all wall mount screws for looseness.
●Select a good location. If not, accidents may occur or the unit may get damaged.
●SHARP is not responsible for accidents resulting from improper installation.
■Driving screws
SHARP designed the unit so you may hang it on the wall. Use proper screws (not supplied). See below for size and type.
| 3.2 mm (1/8”) |
5 mm |
|
(3/16”) | 9 mm (3/8”) |
Min. 22 mm (7/8”)
■Installing the unit
1� Fix the pattern paper to the wall in horizontal position as below.
44 mm
188509mmm
Wall surface 44 mm | 29 mm |
Pattern paper (supplied)
2� Make a hole on the wall following the screw point marks on the pattern paper by using a drill.
32 mm
Wall surface
3� Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface.
32 mm
Wall surface
4� Fasten the screws to the wall as shown below. (Total screw is 2 pieces).
Wall surfaceWall surface 
4.3 ~ 4.8 mm
Gap from the wall surface
5� Hang the unit onto the screws.
Wall surface
■Falling prevention
Safety wires (not supplied) are useful to prevent the unit from falling off the wall.
Screw eye (not supplied)
Wall
Safety wires (not supplied)
Loop the safety wires (not supplied) into each hole as shown and tie the safety wires to a hook (screw eye).
Ø wire > 1.5 mm
The diameter of wire/cable must be less than 1.5 mm.