Sharp DK-KP82PH operation manual Remote control, Battery installation, Test of the remote control

Remote control

■Battery installation

1� Open the battery cover.

2� Insert the supplied battery according to the terminal indicated in the battery compartment.

When inserting or removing the battery, push it towards the (–) battery terminals.

3� Close the cover.

Caution:

●Remove the battery if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage.

●Do not use rechargeable battery (nickel-cadmium battery, etc.).

●Installing the battery incorrectly may cause the unit to malfunction.

●Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

Notes concerning use:

●Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase an “AA” size battery (UM/SUM-3, R6, HP-7 or similar).

●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.

●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.

●Keep the remote control away from moisture, heat, shock, and vibrations.

■Test of the remote control

Check the remote control after checking all the connections. Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below:

Remote sensor

0.2m - 6 m (8” - 20’ )