MOUNTING
Note: Before use, attach your hoist to an overhead pipe using the included brackets as follows:
1.Find the 2 Fixing Rings (#3) and the Hex Head Bolts (#4).
Figure 2. Optional Pole Mount.
Note: Your hoist may be mounted on a fixed overhead pipe, or attached to a pole on a rotating pillar.
Figure 1. Mounting the Hoist.
2.Place the Fixing Rings over a suitable pipe, in the position you wish to mount the hoist.
3.Have an assistant hold the hoist in place while you install the Bolts through the Fixing Rings into the threaded holes in the Fixing Rack (#1) of the hoist.
4.With the hoist in the correct position, firmly tighten the bolts.
OPERATION
1.The cable spool will not turn freely. To pull out or wind up cable, you must operate the power switch.
2.To operate the power switch, take the Handle Base in your hand. Press the upper part of the rocker Switch to reel in the cable. Press the lower part of the rocker cable to reel out cable.
3.Check to be sure it is safe to lift or pull the item.
4.To pull out the cable, grasp the lift hook, and pull it away from the hoist while pressing the lower part of the power Switch . Always leave at least three turns of cable on the spool to prevent pulling the cable out of the Hoist.
5.Attach the cable firmly to the item using the lift hook or pulley lift hook. Never wrap the cable around the object and hook onto the cable itself. This can cause damage to the ob-
REV 02a
SKU 44006 | For technical questions, please call | Page 5 |