Clevis ring and
wire ring
Positioning plate
Square washer
Figure 13
RECLINER POSITIONING MECHANISM
TROUBLE-SHOOTING
ADJUSTMENT INSTRUCTIONS FOR POSITION MECHANISM
NOTE: Never lubricate the position mechanism assembly.
1.Turn the position adjustment handle down to the release position, and remove clevis pin and wire ring from top of assembly (See fig. 13).
2.Slide positioning plate up, and turn square washer clockwise until snug (See fig. 13).
3.Slide the positioning plate down over square washer. Replace clevis pin and wire ring.
4.The position mechanism's handle should engage at about the halfway point. If more tension is desired, repeat the above procedure.
8 | 565G/565PG/565WG |