Health O Meter 2450KL operation manual Preparing the Scale for Use, Replacing Batteries

Page 6

SET UP

Preparing the Scale for Use

1.Remove protective plastic film from keypad and display.

2.Place batteries in the battery holder (see “Replacing Batteries”).

3.Plug the scale’s AC adapter into the power source.

4.Press the ON/OFF button to turn the scale on. The display will show “Health o Meter Pro-Plus” and then ”000Lb00oz”.(a)

5.Place a weight [not to exceed 600 Lb (270 Kg)] on the scale. The display should read “WEIGHING“ until the weight calculation is complete and the weight is displayed.

6.Press the KG/LB button to select the weight mode (Lb/Kg).(b) *

7.Press the REWEIGH button; the scale should perform the weighting process again.

8.Remove the weight from the scale, the scale will return to zero and the display will read “ZERO” on the left upper side of the screen along with ”000Lb00oz”.

9.Disconnect the scale’s AC adapter from the power source. The scale will shut off. Press On/Off and the scale will switch to battery power.

NOTE: If the set up procedure failed, refer to the troubleshooting instructions. If the problem is not corrected, refer to qualified service personnel.

(a)To adjust the display backlight and/or contrast, please refer to page 13.

(b)To change the display mode in pounds to fractions or decimals, please refer to page 8.

Replacing Batteries

Figure 4. Replacing Batteries

(refer to the Parts List on page 21 for details on parts followed by # )

1.Unplug the scale.

2.Remove the battery cover from the display assembly.

3.Disconnect battery holder cable connector from the scale-battery connector.

4.Carefully remove the battery holder by sliding it out the display assembly.

5.Replace the batteries with new ones.**

6.Carefully position the battery holder into the display assembly.

7.Plug the battery holder cable connector to the scale-battery connector.

8.Attach the battery cover to the display assembly and install the screw.

*To change the scale default units to kilograms, or to deactivate the LB/KG button, please contact Technical Support at 1 800 638-3722 or +1 708 598-9100.

**We recommend the use of EVEREADY Energizer® e2TM batteries.

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents
PRO Plustm Portable Wheelchair Scale Table of Contents Specifications Scale Specifications General SET UP Scale Opening and Assembly InstructionsSET UP Preparing the Scale for Use Replacing BatteriesOperation Instructions Description Function Weight Display Mode MenuOnly applies to pound values, not the metric values Automatic Tare Tare WeightData Management Removing the TareEnter Scale Settings Operation Instructions System Settings System Test User Settings Operation Instructions Cleaning MaintenanceMaintenance Disconnect the scale from the AC power sourceTroubleshooting Symptom Possible Cause Corrective ActionCalibration Path Operator Action DisplayExploded View of Scale continue Parts List Description QtyWhat does the Warranty Cover? WarrantyLimited Warranty To get Warranty Service
Top Page Image Contents