Braun 6 manual Decals and Antiskid

Page 37

WARNING

Decals and Antiskid

Decals

Replace missing, worn or illegible decals. Failure to do so may result in serious bodily injury and/or property damage.

The lift is only as safe as the opera- tor. Replace any missing, worn or illegible decals! Part numbers are provided for decals. Inspect your lift for missing, worn or illegible decals. Call 1-800-THE LIFT for replacements.

27024

WARNING

Read manual before operating lift.

Load and unload on level surface only.

Engage vehicle parking brake before operating lift.

Provide adequate clearance outside of vehicle to accommodate lift.

Do not operate lift if you suspect lift damage, wear or any abnormal condition.

Keep operator and bystanders clear of area in which lift operates.

Whenever a wheelchair passenger is on the platform, the:

19342

OPERATING INSTRUCTIONS

Read warnings and operate lift as outlined on LIFT OPERATING INSTRUCTIONS decal. Lift operating instructions apply to wheelchair passengers and standees.

Standee Instructions: Standees must stand at center of platform (fully inside yellow boundaries), grip handrails and lower head to clear door jamb header.

Interlock Instructions: Lift Interlocks vary in type and operation. Interlock (if equipped) must be operated as instructed by transit authority.

Note: Clean surfaces with isopropyl alcohol before decal or antiskid application. Use a clean

25675

WARNING

Lift installation and servicing prohibited by anyone who has not been certified by The Braun Corporation Sales and Service School. Certified service technicians should call 1-800-THE LIFT to receive applicable installation/service manual. Failure to follow this policy may result in serious bodily injury and/or property damage.

25675

27154

WARNING

Improper hydraulic

Passenger must be positioned fully inside yellow boundaries

Wheelchair brakes must be locked

Roll stop(s) must be up

Failure to follow these rules may result in serious bodily injury and/or property damage.

LIFT OPERATING INSTRUCTIONS

OPEN DOOR(S) AND SECURE

TO UNFOLD PLATFORM:

Stand clear and press UNFOLD switch until platform stops (reaches floor level).

Note: In event platform does not unfold, press FOLD switch to

19342

27146

MANUAL

OPERATION

EN

C

O

 

L

P

S

O

E

OPEN

cloth or paper towels. Do not use oily shop rags. Wipe surface free of residue with dry portion of cleaning cloth.

See Decals on page 36 also.

25674

WARNING

Oper

Manuator's

al

Read manual before operating lift. Call 1-800-THE LIFT to receive operator's manual. Failure to do so may result in serious bodily injury

and/or property damage. Keep manual in lift pouch.

25674

22249

WARNING

Contact The Braun Corporation before adjusting hydraulic pressure relief valve. Failure to do so may result in serious bodily

injury and/or property damage.

22249

pressure switch

 

adjustment may result

 

in serious bodily injury

and/or property damage.

HYDRAULIC

 

PRESSURE SWITCH

ADJUSTMENT

 

Adjust switch as specified

in installation/service

 

manual.

27154

release Lift-Tite™ latches.

TO UNLOAD PASSENGER:

1.Load passenger onto platform and lock wheelchair brakes.

2.Press DOWN switch until entire platform reaches ground level and roll stop unfolds fully.

3.Unlock wheelchair brakes and unload passenger from platform.

TO LOAD PASSENGER:

1.Load passenger onto platform and lock wheelchair brakes.

2.Press UP switch to fold roll stop up and raise platform to floor level.

3.Unlock wheelchair brakes and unload passenger from platform.

TO FOLD PLATFORM:

Press FOLD switch until platform stops. Release switch.

CLOSE DOOR(S)

U.S. Patent No. 5,261,779

U.S. Patent No. 6,065,924

 

U.S. Patent No. 5,806,632

Patents Pending

27204

CLOSE

Using hand pump handle:

TO UNFOLD PLATFORM (OUT):

1.Close hand pump valve (turn clockwise).

2.Insert handle in pump and stroke until platform folds fully (stops).

3.Open hand pump valve (turn counterclockwise) until platform reaches floor level. Open 1/2 turn only.

4.Close hand pump valve (turn clockwise).

DOWN (TO LOWER):

Open hand pump valve (turn counterclockwise). Open 1/2 turn only.

UP (TO RAISE):

1.Close hand pump valve (turn clockwise).

2.Insert handle in pump and stroke until platform reaches floor level.

TO FOLD PLATFORM (IN):

Insert handle in pump and stroke.

Close valve before operating electric pump.

27146

Page 35

Image 37
Contents Series Congratulations Contents Introduction Lift TerminologyLift Components Hand-Held Switch Control BoxRegarding Lift-Titelatches are provided on pages 15 Fold switch is pressed Automatic IllustrationFixed Inboard Safety Symbols Safety FIRST! Know That Lift Operation SafetyLift Operation Safety Precautions Lift Operation Safety Within the lift occupant area and clear of moving parts Lift Operation Safety Pre-Lift Operation Notes and Details Down Lift Control SwitchesLift Features Disengaged Lift-Tite Latch Engagement Pin Roller Pre-Lift Operation Notes and Details Fully Folded Fully Unfolded Vertical Stop non-IB Fully-Folded Disengaged Roll Stop Pre-Lift Operation Notes and Details Lift Passengers Pre-Lift Operation Notes and Details Pre-Lift Operation Notes and Details Wheelchair-Equipped Occupant Seat Belts Operation Procedure ReviewPreventive Maintenance Lift Operating Instructions To Unload Passenger Lift Operating Instructions To Load Passenger Close Doors Manual Operating Instructions Follow all Lift Operation Safety PrecautionsTo Lower Platform Down To Unfold Roll Stop To Unfold Platform OutTo Raise Platform To Fold Roll StopTo Fold Platform Decals Decals and AntiskidBefore posting decals Available Antiskid AntiskidMaintenance and Lubrication Independent Bridge Plate non-IB Pivot Points Places Cylinder Code Warranty and Registration InstructionsWarranty and Registration Instructions Providing Access to the World ADA