Braun L200UARS manual Fully Unfolded Roll Stop Ramp position

Pre-Lift Operation Notes and Details

Lift Features (continued)

ing the DOWN switch deploys (unfolds) the roll stop. The roll stop is cylinder powered to automatically fold (rotate) to the vertical position when the UP switch is pressed (roll stop raises before platform raises).

Read warning posted on

opposite page. Discontinue lift operation immediately if the roll stop does not operate properly.

Roll Stop Latch: A spring- loaded latch engages the outboard roll stop when the roll stop rotates upward from the ramp position to the vertical

position (UP switch is pressed to raise the platform above the ground). Note: The platform must raise approximately two inches before the latch engages fully (see photos below).

The latch disengages the roll stop when the platform lowers fully (reaches ground level) and

Fully Unfolded Roll Stop (Ramp position)

Outboard Roll Stop

Disengaged	Fully Engaged
Roll Stop Latch	Roll Stop
	Latch

Note: Platform must raise approximately two inches before latch engages fully.

Fully Folded Roll Stop (Up-vertical)

2" Latch Foot

Page 18