Lift Terminology

Lift Components (continued)

details regarding the outboard roll stop are provided in the Pre-Lift Operation Notes section (pages 17-20).

Roll Stop Latch: The spring- loaded latch locks the outboard roll stop in the vertical position when the platform raises above ground level.

Inboard Roll Stop: L211UARS platforms are equipped with a fixed inboard roll stop. Attendant operation is not required for operation.

Manual Operation Systems: Manual operation systems are provided for use in event of power or equipment failure.

L200UARS Series lifts are equipped with an “over-center” fold actuator manual release system to allow the lift platform to be manually unfolded and folded.

Amanual back-up hand pump is built into the pump module. The lift platform can be lowered and raised using the hand pump.

Complete details and manual operating procedures are pro- vided on pages 31-40.

Lift Actions and Functions

UNFOLD (Out) - Platform Unfold: Unfold is the action of the platform rotating out and down from the fully-stowed (vertical) position to the fully- unfolded (horizontal) position when the UNFOLD (Out) switch is pressed.

DOWN - Platform Lower: Down is the action of the platform lowering when the DOWN switch is pressed. When the platform is unfolded from the stow position, the platform must be lowered from the fully-raised position to the floor level position when unloading a passenger at floor level. The lift operator (atten- dant) must stop the platform at floor level (release DOWN switch). The platform is then lowered to ground level (fully- lowered) to unload and/or load passengers.

DOWN - Roll Stop Unfold (Deploy): When the platform reaches the fully-lowered (ground level) position and the DOWN switch is continually pressed, the outboard roll stop rotates down

Page 6