E&J 3J01-INS-LAB-RevB13 manual Remove Arm, Install Arm

Page 18

ARMS

M10 wrench, M4 hex key

All Traveler HTC arms are fixed.

Remove Arm

1.Use an M10 wrench and M4 hex key to remove bolt and nut that secure arm to front arm socket.

2.Hold arm by center of armpad. Lift straight up and off.

Install Arm

1.Hold arm by center of armpad. Lower arm straight down into sockets.

right arm

nut

bolt

front arm socket

remove arm

2.Install bolt and nut that secure arm to front arm socket as shown above. Use an M10 wrench and M4 hex key to tighten. Ensure nut is tightened and locked in place.

WARNING: Ensure that arms are locked in place before occupying or operating wheelchair.

18

3J01-INS-LAB-RevB13 • Traveler HTC User Manual

Image 18
Contents Hospital Transport Chair Manual Wheelchair Contents Introduction Page Important Safety Precautions Page Page Getting Started Handling Tips BalanceTransfer Activities Reaching / Bending Forward or sidewardBackward Ramps and Inclines AscentDescent Curbs and Steps Assembly AssemblyUnpacking Install Push Handle / Anti-Fold Bar Install Anti-TippersInstall Anti-Theft Pole Install Elevating Legrests or Optional Footrests Adjustments Rear Wheels & CastersInstall Arm Remove ArmElevating LEGREST, Swingaway Remove Elevating Legrest Or Optional FootrestAttach Elevating Legrest or Optional Footrest Adjust Legrest Elevation Raise elevating legrestLower elevating legrest See picture at right Adjust Wheel Locks Tighten CrossbracesMaintenance Do-It-Yourself MaintenanceList of Tools General CareCheck Wheel Lock Engagement Check Tire WearCheck Handrims Check Anti-TippersCheck Backposts / Push Handle Check Rear Wheel AdjustmentCheck Arms Check Elevating Legrests and Optional FootrestsCleaning your Traveler HTC Check CastersCheck Wheel Bearings Troubleshooting SymptomLimited Warranty Scope of WarrantyPage Index