SETTING THE TRANSMIT (TX) POWER
The SOLARA DSC transmits on
Caution: It is important to remember to use the LO position in port or for short range communications.
1.When you turn the radio On for the first time, the unit is automatically set to transmit at 25 watts (HI).
2.Press HI/LO/SCAN/UIC to change the transmitter output to 1 watt (LO).
3.Press HI/LO/SCAN/UIC again to change back to 25 watts (HI).
Note: A short tone sounds everytime you press the HI/LO/SCAN/UIC. CH13 is 1 watt (LO) channel. When the channel is LO power channel, you can transmit at 25 watts (HI) by pressing HI/LO/SCAN/UIC during the call. LO power channels are USA Channels 13, 67, 75, 76; Canadian Channels 13, 15, 17, 20; .
Use low transmit power in harbors or when close to the receiving station.You can not change the transmit power setting on channels which are
14