4. REPLACING THE BATTERY
Should it be necessary to replace the headset battery at anytime please refer to Fig. 5 on page 4.
5. . USING YOUR CS50-USB/CS60-USB HEADSET
PLACING A CALL USING YOUR HEADSET
To place a call using the headset, remove headset from cradle and dial or connect to another user in the normal way. To end the call, replace the headset in the charging cradle or press the Talk button (3).
If you have selected an outgoing line in the PerSonoCall software, by pressing the Talk button (3) on the headset you will hear dial tone. You can then dial in the normal way.
Tip: By returning to standby mode after completing your call, you will conserve the headset battery power and extend the remaining available talktime. You can achieve this by pressing the Talk Button (3) for more than 2 seconds immediately on conclusion of the call.
RECEIVING A CALL USING YOUR HEADSET
If the headset is in the charging cradle when the softphone rings, remove the headset to answer the call. To end the call, replace the headset in the charging cradle or press the Talk button (3).
If the headset is not in the charging cradle when the softphone rings, press the Talk button (3) to answer the call. To end the call, replace the headset in the charging cra- dle or press the Talk button (3).
Tip: By returning to standby mode after completing your call, you will conserve the headset battery power and extend the remaining available talktime. You can achieve this by pressing the Talk Button (3) immediately on conclusion of the call.
SWITCHING BETWEEN CALLS USING THE HEADSET
Some softphones support a feature known as ‘flash’. This allows you to place the cur- rent call on or off hold, or to toggle between different calls. You can access the flash feature by pressing and holding the Volume up/down (4) on the headset for greater than 2 seconds.
12