Toshiba FT-8801A manual Setting UP the Base Unit Wall Mounting, Mounting on a Standard Wall Plate

Page 11

INSTALLATION

SETTING UP THE BASE UNIT (WALL MOUNTING)

MOUNTING ON A STANDARD WALL PLATE:

Insert the bracket’s tabs into the notches on the base.

Preparation

Flip the hook tab over so the tab holds the handset.

Raise the antenna.

Telephone

Line Cord

Single-Line Telephone Jack (RJ11C)

Power Outlet

(AC 120 V, 60 Hz)

AC Adaptor

•Route the cords through the guides.

•Place the base unit on the posts of the wall plate and push down until it is firmly seated.

NOTES:

•Do not use any outlet controlled by a wall switch.

•If you don’t have a standard wall plate, cut out the template on this page and use it to position two screws (minimum length of 13/8 inches) into the wall with the heads protruding about 1/4 inch.

CUT

CUT

Wall mount template

IMPORTANT:

•Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone.

•Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard.

11

Image 11

Contents Page Getting Started do this First Introduction FeaturesTable of Contents Table of Contents Important Safety Instructions Batteries Important Safety InstructionsHandset Location of ControlsBase Unit AC Adaptor Information InstallationSetting UP the Base Unit Desk TOP Mounting Mounting on a Standard Wall Plate Setting UP the Base Unit Wall MountingCharging the Battery Pack Low Battery Setting the Dial Mode Setting or Canceling the Auto Talk Function Setting the Area Code Receiving a Call Basic OperationMaking a Call OUT of Range Handset Earpiece Volume SettingHandset Ringer Volume Setting RedialPaging the Handset TONE/PAUSEInterference or Static Storing Numbers Memory DialingMemory Dialing Steps for Entering Names and Special Characters If YOU Make a Mistake While Entering a Name Dialing a Stored NumberEditing and Deleting Stored Numbers Deleting the Stored Data Caller ID/CALL Waiting Answering a Call with Caller ID ServiceCaller ID/CALL Waiting Calling Back from the Caller ID List Searching Caller ID MemoryStoring to SPEED-DIAL Memory Editing Caller ID DataDelete Individual Caller ID Data Deleting Caller ID DataDelete ALL Caller ID Data Problem Solution TroubleshootingTroubleshooting FCC Requirements WARRANTY/SERVICEService Requirements Important Instructions to UsersTELEPHONE/TELEPHONE Answer Machine Limited Warranty Quick Model no