5312 and 5324 IP Phone SIP User and Administrator Guide
- 20 -
Call Handling
Hold
The 5324 IP Phone supports a maximum of four held calls at the same time. The 5312 IP
Phone supports a maximum of two held calls.
When you place a call on hold, or when another party puts you on hold, the on-hold beep
reminds you that you are holding or on hold. If the handset is in its cradle, you hear the beep
through the handsfree speaker. You can turn off this beep, if desired.
Note:
You cannot change your hold settings while on a call.
Hold a Call
•
Press
(
HOLD
). The associated
Line
key flashes.
Retrieve a Call from Hold
•
Press the associated flashing
Line
key. The
Line
key changes from flashing to lit solid.
Change On-Hold Settings
•
Access
the
Feature Configuration
page of the Web Configuration (see
Accessing the
Web Configuration Tool
on page 7).
Call Forward
Call Forward redirects incoming calls to your voice mailbox (by default) or to an alternate
number. Choose from the following Call Forward options:
•
Call Forward – Always
redirects all incoming calls
•
Call Forward – No Answer
redirects calls if you don’t answer after the programmed
number of rings (1 – 10)
•
Call Forward – Busy
redirects calls when all lines are busy.
All Call Forward options are OFF by default. You can turn on Call Forward No Answer and
Call Forward Busy at the same time.
Note:
You cannot change your Call Forward settings while on a call.
Note:
To program and enable or disable Call Forward using the Web Configuration Tool,
access the tool’s
Feature Configuration
page (see
Accessing the Web Configuration
Tool
on page 7).
Program Call Forward
1. Press (
SUPERKEY
), and then press
>>
until FEATURES? appears.
2. Press
OK
. CALL FORWARDING? appears.
3. Press
OK
. FWD ALWAYS: <current status> appears.