7.3 Storing a redial number
To store a redial number, complete the following:
1.Repeat steps
2.Press the REDIAL button.
3.Press the MEM button again to store the number.
• You will hear a confirmation tone.
To replace an old redial number, complete the following:
1.Repeat steps
2.Press the MEM button.
•REPLACE MEMO shows in the display.
3.Press *TONE/CANCEL to exit, or press the MEM button again to replace the old redial number with a new redial number in that memory location.
•You will hear a confirmation tone.
7.4 Dialing a stored number
There are 2 ways to dial a stored number.
A) To dial a stored number:
1.Make sure the cordless phone is ON by pressing the TALK/CALL BACK button.
2.Press them MEM button.
3.Press the number (0 to 9) for the desired memory location.
• The number will dial automatically.
B) To dial a stored number:
1.Make sure the cordless phone is OFF (not in TALK mode).
2.Press the MEM button.
3.Use the 
or 
button to scroll through the stored numbers in memory until the desired number is shown.
4.Press TALK/CALL BACK.
•The number will dial automatically.
7.5 Inserting a pause in the dialing sequence
You may insert a delay into the dialing sequence of a stored number. This is sometimes necessary when a pause is needed to wait for a dial tone (for example, after you dial 9 to access an outside line, or to wait for a computed access tone).
To insert a pause, press the # pause key twice within one second when storing a phone number. The pause in the number will be shown with a P.
7.6 Reviewing and deleting numbers
You may review and/or delete stored number by completing the following:
1.Press the MEM button, then use the use the 
or 
button to scroll and view the number.
2.While the desired entry is displayed, press the CH/DELETE button to delete the entry.
•The display shows DELETE?
3.Press *TONE/CANCEL to exit, or press the CH/DELETE button again to delete the entry.
•If the CH/DELETE button is pressed, DELETED will be shown on the display.
13
GN7170_userguide.ind 13
13/08/04 9:56:08