Draft
8/14/02a
INSTALLATION
¥NOTE: Install this telephone away from electronic equipment, such as personal computers, television sets
or microwave ovens. Avoid excessive heat, cold, dust or moisture.
1Connect the telephone line cord. (figure a)
2Connect the power cord to the base and an electrical outlet not controlled by a wall switch. (figure a) The ANSWER ON/OFF light goes on, and CL flashes in the message window.
Use only the power cord supplied with this product. If you need a replacement, call 1 800
3Install the handset battery. Use only AT&T Battery 2401, SKU# 91077. (figure b)
4Charge the handset battery.
•Place the handset in the base.
•Charge the battery at least 12 hours. After the first charge, the battery will charge in eight hours.
5Check for dial tone.
•After the batteries are charged, lift the handset and press P; you should hear a dial tone.
For detailed installation instructions, to use the belt clip, or to use a headset with this phone please refer to the INSTALLATION section of your User’s Manual.
Standard | Modular |
electrical | telephone |
outlet | jack |
Power cord | Line cord |
figure a |
|
QUICK START GUIDE
5.8GHz Cordless Telephone 5830 with Talking Caller ID/Call Waiting
a) Remove battery | b) Align the | c) Replace cover |
compartment | contacts and | by sliding it on |
cover by pressing | place the battery | its track up over |
on the raised | pack in the | battery case until |
spot and sliding | battery | it snaps firmly |
downward. | compartment | into place. |
figure b |
|
|
|
|
|
FEATURE SETUP
Dial Mode (Tone/Pulse)
This phone comes set for touch tone dialing. If you have dial pulse (rotary) service, you must set the dial mode to PULSE.
1Make sure the handset is off.
2Press ***on the base. You will hear a tone and the LINE IN USE light will flash.
3Press 0. If the IN USE light goes on, you have selected TONE. If the light goes off, you have selected PULSE. Press 0again to change your selection.
4Press #to save your selection
— OR —
Press *to exit without saving.
Set Time
You can choose to set the time manually, or you can allow it to be set automatically with incoming Caller ID information.
1 Press MENU on the handset.
2Press 
until the screen displays
CALLS LOG
INTERCOM
HANDSET SETTINGS
SET TIME
|
| ▲ | OK | ▼ |
3 | Press | OK . The screen displays the current time setting. | ||
| Use | to move the cursor, and use the keypad to | ||
| change a digit. Select AM/PM . |
|
| |
4 | Press | SAVE to save the displayed time. |
|
|