GN Netcom 5830 user manual Wall Installation, Figure a Position the mounting bracket as

5830_CIB_1ATT 8/14/02 9:47 PM Page 5

Wall Installation
1	Connect the power cord and	INSTALLATION
	telephone line cord to the underside
	of the corded base, as shown
	(figure a).
2	Position the mounting bracket as
figure a	shown (figure b).
3	Feed the telephone line cord through
	the hole in the center of the
	mounting bracket (figure b), align
	the bracket with the base, and slide
	into the hole on the base as shown

(figure c).

4 Lock the mounting bracket in place

figure b

figure c

(figure d).

5Plug the telephone line cord into a modular wall jack, and mount the base on the wall (figure e).

a)Align holes on base with mounting studs on wall jack.

b)Place power cord as shown.

c)Pull base down on mounting studs until it locks into place.

6Plug the power cord into an electrical outlet not controlled by a wall switch (figure e).

Use only the power cord supplied with this product. If you need a replacement, call 1 800 222–3111.

7 Follow Steps 3–5 in “Table/Desktop

Installation.”

figure d

figure e

5