Lucent Technologies LULCST manual Option Switch Setting, SET Switch

NOTE: When the switch #7 is “O FF”, the re will be no delay in time from when the paging system zone is accessed until the time when the message is sent. When the switch #7 in “ON” , there will be a 2 second delay from when the paging system/zone is accessed until the time when the message is sent. The delay is installed in order for a Confirmation/ Pre-announcement tone (if available or optioned) to be played over the system before the message is sent.

2.Set the option switch on the Call Stacker (see Figure 3-1on page 3-2) for the desired system configuration (refer to Table 2-1).

Table 2-1. Option Switch Setting.

NOTE: PBX and KTS stations must have the ability to send a forward disconnect to the Call Stacker's Station inputs.

3. Connect the Call Stacker to the paging system (see Figure 2-4):

■Connect the Call Stacker's Page Output to the attendant override (attendant access control leads) or incoming alarm signal from the paging system.

■Connect one or more of the Call Stacker's Input Station channels to PBX/KTS analog station inputs on the telephone system through FCC/DOC approved modular jacks.Connect the Call Stacker's Page Output channel to the paging system as shown in Figures 2-4and 2-5through an FCC/DOC approved modular jack. The control contact signal is used to secure and release the paging system controller (see figure 2-3).