Recording Announcements
Voice Prompts Enabled
NOTE: If the number of digits in the paging zone is set to 0 (see Table
“Start recording, press the pound key to end or hang up (Empieze a grabar el mensage, para terminar la grabación c uelge o marque la tecla de numero)” followed by a high tone. Skip step 2 and proceed to step 3.
IMPORTANT: If all the recording time is used up, the Call Stacker answers the trunk and responds with “No recording time available (No hay tiempo de grabación disponible)” or
“Message not recorded (No hay mensajes grabados)” then disconnects. If this occurs wait a few seconds before re- attempting to record the announcement.
NOTE: Press the “#” key while the voice prompts are playing to interrupt (and skip) them.
1.Dial up the input station connected to the Call Stacker. The Call Stacker answers the trunk and responds “Enter zone code (Marque el codigo de la zona)” . Proceed to step 2.
2.Enter a DTMF tone sequence using the telephone keypad to select a paging zone.
■Once the required number of DTMF digits (see Table
3.Record the announcement. To end recording, either:
■Hang up to enter the recorded announcement into the queue, or
■Press the “ #” key to hear the recorded announcement. The Call Stacker responds “Hang up if finished, press zero to
Operation