Jwin JT-P433 Ringer Volume Control, Handset Volume Control, Speaker Volume Control

Page 12

Vintage Design Telephone with Caller ID

V10M10_IM_EN_01282008

OPERATIONAL INSTRUCTIONS

Basic Setup-continued

R.RINGER VOLUME CONTROL

-Under off- hook state, press VOLUME to enter the setting

-The LCD will display “RING VOLUME” and “-2-”(the volume level).

-Press VOLUME to select the ringer volume level.“1”is low level, “2”is high level and “OFF” is ringer off.

Note: If you choose ringer off, you can still dial out, but cannot hear ringer sound of any incoming calls. (Ringer LED will still flash to remind you there is incoming call.) Don’t forget to set the ringer to ‘ON’ (i.e. select volume level ‘1’ or ‘2’), otherwise, you cannot hear the ringer on next time

S.HANDSET VOLUME CONTROL

-Pick the handset and press VOLUME to enter the setting

-The LCD will display “HANDSET VOLUME” and “-3-” (the volume level).

-Press VOLUME to select the handset volume level from 1-4. (‘1’ is the lowest volume and ‘4’ is the highest.)

T.SPEAKER VOLUME CONTROL

-Under the speakerphone in use status, press VOLUME to enter the setting

-The LCD will display “SPEAKER VOLUME” and “-3-” (the volume level).

-Press VOLUME to select the speakerphone volume level from 1-4. (‘1’ is the lowest volume and ‘4’ is the highest.)

U.KEYPAD SECURITY LOCK

-Under off-hook state, press “*#0000#” (‘0000’ is default as security code) to set as keypad unlock or all lock.

-For example, if press “*#0000#” once, the keypad will be locked. No any outgoing call is allowed. Press “*#0000#” again to unlock the keypad.

-If you want to change the security code, under off-hook state, press “*#xxxx*yyyy#” (xxxx means the old security code, yyyy means the new security code)

Note: If you forget the old security code, then use ‘6666’ as old security code

- 11 -

www.jWIN.com

Image 12
Contents JT-P433 User Safety Guide Important Safety InstructionsCompliance USA and Canada Vintage Design Telephone with Caller ID V10M10IMEN01282008 Table of Contents General Features Getting StartedPackage Location of Controls ReceiverNumber Auto / VIP Speaker LCD ScreenInstalling the Batteries Getting the Telephone Ready for UseBasic Setup Operational InstructionsSET Alarm Clock SET Ringer MelodySET VIP Ring Melody SET Flash TimeSET Dialing Mode SET Voice Target NumberSET Voice Reporting ON/OFF SET Call Forward to Voice MailRinger Volume Control Handset Volume ControlSpeaker Volume Control Keypad Security LockRecieving Caller ID Information Reviewing the Caller ID ListErasing Data From the Caller ID List Calling Back a Number from the Caller ID ListPhonebook Review Phonebook InputPhonebook Delete or Edit Set Auto IP On/OffDialing IP Number Storing 2 One-Touch Dialing MemoriesStoring 2 One-Touch Dialing Memories from Incoming Calls Dialing From One-Touch MemoriesDialing from Two-Touch Memories Deleting a Two-Touch Memory NumberForwarding a Call to an Extension Line VIP FunctionNew Incoming Call Indicator Last Number RedialFlash Function Conversation Time IndicationTroubleshooting & Specifications TroubleshootingSpecifications Vintage Design Telephone with Caller ID V10M10IMEN01282008 TEL FAX