Lenoxx Electronics PH559 Basics, Choosing Tone or Pulse Dialing, Making and Receiving Calls

Page 10

GETTING STARTED

Step 4: Setting up the Telephone (Continued)

SETTING UP LANGUAGE, AREA CODE, TIME AND DATE (Continued)

Your phone will now go to the Time and Date mode, press the UP and DOWN buttons to get to the correct number and the DELETE button to accept.

You do not have to set up the Time and Date because the telephone company will auto- matically update this with your Caller ID when your phone rings (twice or more). To get back to the standby mode (for dialing), press the DELETE button until the normal display shows (see below for example):

(Example: 10:53 a.m. On June 18th)

TO RESET THE PHONE

In the rare case of abnormal telephone line interference, your phone may not work properly and may need to be reset. Make sure the phone is hung up, use a pointed object like a straightened paper clip and stick it into the small hole at the bottom of the phone (marked RESET) for 2 seconds. The display will become blank for about one second, then resume to the previous display. Note you do not need to reprogram the memory numbers you stored.

BASICS

Choosing Tone or Pulse Dialing

Select the type of dialing that you desire or that your telephone system requires by setting the TONE/PULSE switch.

TONE - The set will operate using tone dialing.

PULSE - The set will dial using rotary dial type pulses (clicking sounds).

If you are not sure of your dialing system, make a trial call with the switch set to TONE. If the call connects, leave the switch as it is; otherwise, set it to PULSE.

NOTE: To use caller ID service, you will probably need TONE dialing.

Even when your phone is set to pulse service, this phone can be switched to temporary tone for access to services that require tone signaling including Telephone Banking. Just

press the TONE button after dialing in pulse and your buttons can now be used for tone signaling for this call only.

Making and Receiving Calls

MAKING A CALL

1.

Pick up the handset to get a dial tone. The hook icon

will show in the display.

2.

Dial the phone number. The dialed number appears on the display.

3.

When you finished talking, replace the handset into the base.

RECEIVING A CALL

1.Pick up the handset when the phone rings. The hook icon will show.

2.After a few seconds, the Count up timer will start.

3.When you finished talking, replace the handset into the base.

8IB-PH559(9803C)-WM-E-042602

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Memory Call Waiting Caller ID Speaker Telephone Operating InstructionsTable of Contents For customer service Important Safety InstructionsBattery Safety Instructions Important Telephone Company & FCC Information Location of Controls 18 19 20Checking the Package Contents Getting StartedPowering the Phone Using BatteriesConnecting the Telephone Telephone InstallationSetting up the Telephone Setting UP LCD CONTRAST, LANGUAGE, Area CODE, Time and DateMaking and Receiving Calls BasicsChoosing Tone or Pulse Dialing Making a CallHands-Free Speakerphone Operation Volume Control and Ringer SettingLast Number Redialing and Pause Function Telephone Features Memory DialingCall Waiting Caller ID Features Understanding the Caller ID ServiceWhen You Received a Call Viewing the Caller ID ListCalling Back From the Caller ID List Caller ID FeaturesStoring the Phone Numbers from the Caller ID List Using Message Waiting/Mailbox Deleting the Data from the Caller ID ListWall Mounting Slide OUT Reverse Replace Into PhoneInstallation on Masonry P O R TA N TTrouble Shooting Trouble Shooting Limited Warranty
Top Page Image Contents