WALL MOUNTING (continued)
Wall Mounting Without A Modular Wall Phone Plate
Follow these instructions to mount the phone on the wall without a wall plate:
1.Locate a wall stud. If it is possible to utilize a wall stud for mounting, dry wall expanders or a similar type fastener is recommended. Consult your local hardware stores for details.
2.Drill 2 holes 3 15/16" (100 mm) apart.
3.Put a screw into each hole and leave 3/16" (5mm) of the head exposed to mount the phone (screws are not included).
4.Connect the straight cord to the phone and jack.
5.Place the TELEPHONE BASE on the 2 mounting screws and gently push down to lock into place.
Drill one hole
Make sure space between holes is 100 mm
Drill other hole
I M P O R TA N T
Before mounting the phone onto the wall, select a wall area with sufficient strength. If mounting on the wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone.
Installation on Masonry
1.Use a 1/4" masonry drill bit and drill the 2 holes (spaced as above).
2.Insert plastic anchors and install the 2 screws.
3.Leave 3/16" (5 mm) of the screws exposed to mount the phone.
4.Place the TELEPHONE BASE on the 2 mounting screws and gently push down to lock into place (anchors and screws are not included).
MOUNTING AREA
MOUNTING SCREW
ANCHOR
3 15/16”
(100 MM)
3/16” (5 MM)
LEAVE 3/16” (5 MM) SCREW EXPOSED
DRILL HOLE WITH 1/4” MASONRY BIT
14 | |
|